Bedienungsanleitung Harman Kardon AVR355 (Seite 23 von 58) (Englisch)

502548

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

System Configuration

Figure 6

Step 6: After you select “Continue”, the screen

shown in Figure 6 will appear. Although the AVR

may be used with up to eight speakers, you may

ave elected not to install surround back speak-

ers at this time, or you may have decided to use

the surround back speaker channels to power

speakers in the remote room of a multiroom sys-

tem. This screen directs you to program EzSet/EQ

for a 5.1- or 7.1-channel configuration. Select

the setting that reflects the number of speakers

installed in your system, and EzSet/EQ will do

the rest automatically!

NOTE: If you are using fewer than six speakers

in your system, then it will not be possible to

configure your speakers using EzSet/EQ, and you

will need to select Manual Configuration as

described starting on page 24. If you have

selected a 6.1-channel configuration, using only

a single surround back speaker, it is possible to

use a combination of EzSet/EQ automatic

configuration for 5.1 speakers, connect the

single surround back speaker to the left

Surround Back Speaker Output, and then

configure the surround back speaker manually,

as described from page 25. However, we do not

recommend the 6.1-channel configuration.

If you have forgotten to plug in the EzSet/EQ

microphone, the warning screen shown in

Figure 7 will appear as a reminder.

Figure 7

NOTE: As shown in the Figures, while EzSet/EQ

is in progress a Cancel setting is highlighted.

You may interrupt EzSet/EQ at any time by sim-

ply pressing the OK Button X.

IMPORTANT NOTE: Anyone with hearing that

is sensitive to loud noises should leave the room

at this point, or use ear protection sufficient to

reduce the noise level. Inexpensive foam-style

ear plugs, available at most drug stores, may be

used to reduce the sound level to a tolerable

level. If you are uncomfortable with, or cannot

olerate, loud sounds and do not use some sort

of ear protection, we strongly recommend that

you leave the room and ask someone else to run

the EzSet/EQ process, or that you do not use

EzSet/EQ and enter the configuration settings

manually, as described on pages 24 through 27.

Figure 8

Step 7: Once EzSet/EQ has been started, you

will hear test signals circulate among all of the

speakers as the system sets the master level,

checks to see where there are speakers, sets the

distance measurement and calculates delay time

settings, sets the speaker “size”, and sets the

speaker crossover point. During the measure-

ment and calibration process, you may observe

the progress of the testing by reading the

messages that appear in the second line of the

menu listing.

EzSet/EQ uses the left front speaker to set the

master volume level, and then it proceeds

directly to measuring the speaker output levels.

Step 8: When the EzSet/EQ process has fin-

ished, a screen will appear with its results.. You

may press the OK Button X, and the

Speaker Setup screen shown in Figure 4 will

appear.

Unplug the microphone and store it in a safe

place so that it is available to recalibrate your

system if needed due to a change in speakers,

preferred listening position, or a major change in

the room’s furnishings (such as the addition of

thick carpeting or plush furniture) that might

require different settings.

When you have successfully completed the

EzSet/EQ process and made any needed adjust-

ments to the input and surround mode configu-

rations, your receiver is ready for use. If you do

not wish to make any manual adjustments to

the settings, you may skip the rest of this section

and proceed to the Basic Operation section of

his manual on page 30 to learn how to operate

AVR 255/AVR 355. For those situations where

you may wish to make a change to the settings

entered by EzSet/EQ, follow the instructions on

the following pages.

ENGLISH

SYSTEM CONFIGURATION 23

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon AVR355 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon AVR355

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info