502655
17
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
Installation, Setup and Configuration
7. Connections to a subwoofer are made
via a line level audio connection from
the Subwoofer Output to the line
level input of a subwoofer with a built-in
amplifier. If a passive subwoofer is used,
the connection first goes to a power
amplifier, which will be connected to one
or more subwoofer speakers.
Video Input and Output Connections
Video connections are made in a similar
fashion to those for audio components.
Again, the use of high-quality intercon-
nect cables is recommended to preserve
signal quality.
1. Connect the VCR’s audio, video and
S-Video OUT jacks to the Video In jacks
ek on the rear panel. The audio, video
and S-Video IN jacks on the VCR should
be connected to the Video Out jacks
fj on the AVR85.
2. Connect the audio and video outputs
of a satellite receiver, cable TV converter
or television set or any other video source
to the TV jacks ª.
3. Connect the audio, video and S-Video
outputs of a DVD or laser disc player to
the DVD jacks .
4. Connect the TV Mon gh jacks on
the receiver to the video, or S-Video
inputs, of your television monitor or
video projector.
5. As the AVR85 does not mix or change
between standard composite video and
S-Video signals, both monitor connec-
tions must be made if you use both
signal systems.
Note: The on-screen menus are visible
on the composite video output only.
System and Power Connections
The AVR85 is designed for flexible use
with external control components and
power amplifiers. These connections are
easy to make during an initial installa-
tion, or at a later date should you choose
to upgrade your system.
Remote Control Extension
If the receiver is placed behind a solid or
smoked glass cabinet door, the obstruc-
tion may prevent the remote sensor from
receiving commands. In this event, an
optional remote sensor may be used.
Connect the output of the remote sensor
to the Remote Cont. In jack c.
If other components are also prevented
from receiving remote commands, only
one sensor is needed. They may use this
unit’s sensor or a remote eye by running
a connection from the Remote Cont.
Out jack d to the Remote In jack on
Harman Kardon or other compatible
equipment.
Multiroom System Connections
The AVR85 is capable of sending a sepa-
rate source from the one being listened
to in the main listening room to another
room in the house, and having the vol-
ume and source selection of the remote
room feed be controlled by an optional
infrared remote control.
Connect the Multiroom Audio
Outputs i to the input of the optional
audio amplifier that powers the remote
room speakers. If no remote sensor is
connected in the second room zone, the
level may be set via the AVR85’s setup
menus (see page 34).
True multiroom remote control is possi-
ble by placing an optional infrared sen-
sor in the second room zone. The cable
from that sensor should be connected to
the Multi IR remote input b on the rear
panel.
See page 34 for complete information on
using the AVR85’s Multiroom capabilities.
External Audio Power
Amplifier Connections
If desired, optional external power audio
power amplifiers may be used with the
AVR85. Connections to these amplifiers
are made by using audio interconnect
cables connected to both the Preamp
Outputs on the rear panel and
the audio input jacks of the external
amplifiers.
AC Power Connections
This unit is equipped with two accessory
AC outlets. They may be used to power
accessory devices, but they should not be
used with high-current draw equipment
such as power amplifiers. The total power
draw may not exceed 50w to each outlet.
The Switched outlet will receive
power only when the unit is on. This is
recommended for devices that have no
power switch, or a mechanical power
switch that may be left in the “ON”
position.
Note: Devices with electronic power
switches may only go into a Standby
mode when plugged in here.
The Unswitched outlet will receive
power as long as the unit is plugged into
a powered AC outlet.
Finally, when all connections are com-
plete, plug the power cord into a non-
switched 120-volt AC wall outlet. You’re
almost ready to enjoy the AVR85!
14
AVR85 120 rev (g) 6/14/97
AVR85 om (g) 9/16/98 11:21 AM Page 14
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Harman Kardon AVR85 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info