Bedienungsanleitung Harman Kardon AVR85 (Seite 28 von 40) (Englisch)

502655

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

On-Screen Display

AVR85 120 rev (g) 6/14/97

On-Screen Menus

The AVR85’s on-screen menu system pro-

vides both a window into the operation of

the unit and a means of easily adjusting

many system parameters. In addition to

their use in the setup and configuration

of the AVR85, the menu system provides

an easy means of operating the unit.

To activate the On-Screen display system,

press the OSD button k on the remote

for three seconds. This will cause a status

summary display to be shown on the

screen for ten seconds (see figure #6).

Once the video displays are enabled, this

status screen will also appear when the

unit is turned on.

Note: In order to view the on-screen

menu displays the receiver must be con-

nected to the standard, composite video

input of a TV monitor or projector. The

on-screen displays are NOT visible via the

S-Video output.

The status screen displays the following

information:

AUDIO SOURCE: This is the input

currently selected for audio.

VIDEO SOURCE: This is the input

currently selected for video.

TAPE MONITOR: If “ON” is

displayed in this line the output

of the AVR85 is the tape recorder

connected to the Tape1 Inputs §

rather than the actual source. This

function is used to monitor a

recording in progress.

DIGITAL INPUT: If a

digital audio source is selected, it

is displayed here.

MODE: This is the currently selected

audio/surround mode.

MULTI-ROOM: This is the source

currently selected for listening in

remote room locations.

MASTER VOLUME: This is the cur-

rent volume. The scale uses double ver-

tical bars

to indicate the volume level,

while single horizontal dashes

indi-

cate additional range available for

increased volume. The “0dB” reference

point is shown by a solid block

Function Displays and Messages

Once the On-Screen Displays have been

activated, they appear when certain

functions are performed from the front

panel buttons or the remote control.

These messages display the current

function shown on the top line and

information about the selection or

choice on the bottom line.

The following function/operation display

screens are available:

Output Level Display and Adjust

To view an on-screen summary of the

output levels for each channel (see

figure #9) press the Ch Select m.

While this menu is displayed the output

levels may be adjusted using the

Speaker buttons n. Press the Ch

Select button again to change the

channel being adjusted.

This screen enables adjustment of the

output levels using an external source

such as a test disc. This menu also

provides a means of adjustment of the

subwoofer output level which is not

possible elsewhere in the control system.

AUDIO SOURCE : TUNER

VIDEO SOURCE : VCR2

TAPE MONITOR : OFF

DIGITAL INPUT: **

MODE : DOLBY

PRO LOGIC

MULTI ROOM:TUNER

MASTER VOLUME

||||||||||||||||||||||||||



||

Figure 6

AUDIO:TUNER

VIDEO:VCR1

DIGITAL:**

Figure 7

MODE :DOLBY

PRO LOGIC

DELAY TIME:20ms

Figure 10

FRONT L : + 1dB

FRONT R : - 2dB

CENTER : + 1dB

SURROUND L : -10dB

SURROUND R : + 3dB

SUBWOOFER : -10dB

Figure 9

MASTER VOLUME

||||||||||||||||||||||||||



||

Figure 8

AVR85 om (g) 9/16/98 11:21 AM Page 25

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon AVR85 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info