Bedienungsanleitung Harman Kardon BDS 477 (Seite 14 von 38) (Englisch)

531040

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

BDS

Mounting Options for Satellite and Center Speakers,

and Connections

You can pivot the wall-mounted speaker from side to side; however, attempting to tilt it up

or down will damage the bracket and possibly the wall, which would not be covered by your

warranty.

Wall-Mounting the BDS 700 Center Speaker

Determine the location for the speaker (see 1. Placing the Speakers (BDS 800, BDS 700, BDS

400 and BDS 300 Systems), on page 10, for more information). If possible, position the

speaker so that one of the mounting screws (not included; use size #10) can be installed

directly into a wall stud. If that is not possible, use optional wall anchors that are rated

to support at least 25 lb (11.3kg) and are appropriate for the construction and materials

of your wall. The customer is responsible for the proper selection and use of

mounting hardware, available through hardware stores, to wall-mount the

speaker properly and safely.

Bring the speaker cable through the wall-bracket attachment plate as shown, and mount 2.

the attachment plate on the wall in the desired location.

Use Mounting Hardware Appropriate for

Wall Construction and Materials

Bring Cable Through Opening

Remove the rubber pads from the foot rests on the bottom of the center speaker and 3.

connect the speaker leads to the terminals on the underside of the speaker. Remember to

observe the correct polarity. See Connecting the Speaker Terminals (BDS 700 and BDS 300

systems), on page 15, for more information.

Connect Cable

Remove Pads

Use the supplied screws to attach the speaker to the wall-mount bracket. The screws 4.

thread into the center foot-rest openings that were exposed when you removed the

rubber pads in the previous step.

Use Supplied Screws to Attach

Speaker to Bracket

Thread Screws into Center Openings

Connections

CAUTION: Before making any connections to the BDS receiver, ensure that the

receiver’s AC cord is unplugged from the receiver and the AC outlet. Making

speaker connections with the receiver plugged in and turned on could damage

the speakers.

Speakers and receivers/amplifiers have corresponding (+) and (–) connection terminals. Your

system’s satellite speakers use red to denote the (+) terminal and black for the (–) terminal.

The

BDS 2 receiver uses white to denote the left channel (+) terminal and red for the

right channel (+) terminal. Black is used to denote the (–) terminal of both channels.

The

BDS 5 receiver uses the following colors to denote the (+) terminals of the various

channels:

Front Left (+): White Surround Left (+): Blue

Front Right (+): Red Surround Right (+): Gray

Center (+): Green

Black is used to denote the (–) terminals of all channels on the BDS 5 receiver.

The speaker wires included with your system have colored bands at both ends of the (+)

conductor; the colors correspond to the receiver’s (+) terminal colors. This system helps you

connect each speaker to the correct receiver or amplifier terminals. In addition to the colored

bands at each end, each speaker wire’s (+) terminal has ribs molded into its insulation to

help identify it.

Be sure to connect each speaker identically: (+) on the speaker to (+) on the receiver or

amplifier, and (–) on the speaker to (–) on the receiver or amplifier. Miswiring one or more

speakers results in thin sound, weak bass and a poor stereo image.

CAUTION: Make sure the (+) and (–) bare wires do not touch each other or the

other terminal. Touching wires can cause a short circuit that can damage your

receiver or amplifier.

Connecting the Satellite and Center Speakers (BDS 800 and BDS 400

systems)

+– +–

+–+– +–

Surround Right*

Front Right

* Speakers included only in BDS 800 system

Front Right Cable

(Red Bands)

Surround Right Cable

(Gray Bands)

Front Left Cable

(White Bands)

Surround Left Cable

(Blue Bands)

BDS Receiver (BDS 5 shown)

Center Cable

(Green Bands)

Surround Left*

Front Left

Center*

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon BDS 477 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon BDS 477

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info