GPS-910/810
33
ENGLISH
MAKING CONNECTIONS TO THE MOUNTING BRACKET
1. Connect the car charger to the rectangular connector on the right side of
the mounting cradle (below).
IMPORTANT: The GPS-910/GPS-810 will only receive TMC traffic service information
while it is attached to the mounting cradle and the car charger is connected to the
cradle and the vehicle’s 12V power port.
2. If you’re using the optional GPS-MIC Hands-Free Microphone, connect it to
the upper connector on the left side of the mounting cradle (above).
3. If your vehicle’s audio system has an A
UX IN jack you can connect it to the
lower connector on the left side of the mounting cradle (above). This will
provide the best quality audio performance from your GPS-910/GPS-810.
NOTE: The Audio connector fits a 3.5mm stereo mini plug.
LISTENING TO AUDIO IN YOUR VEHICLE
There are three ways you can listen to audio from your GPS-910/GPS-810 in your
vehicle:
1. Through your vehicle’s A
UX IN audio connection (see above).
2. Through your vehicle’s FM radio (see FM Settings, on page 33).
3. Through the built-in speaker.
IMPORTANT: DO NOT USE HEADPHONES WHILE DRIVING!
The installation and use suggestions provided by the manufacturer may be sub-
ject to restrictions or limitations by federal, state or local laws. The user should
determine whether the installation and use of this device is governed by any
law, prior to installation or use.
Plug Car Charger
Into Right Side
of Cradle
To Vehicle Audio System
AUX IN Connection
Plug Car Charger
Into Vehicle’s 12V
Power Port
Optional
GPS-MIC
Hands-Free
Mic
Plug Optional Hands-Free Mic
Into Upper Connector
Plug Lower Connector Into
Vehicle Audio System’s AUX IN
Optinal
GPS-MIC
Hands-Free
Mic
To Vehicle Audio System
AUX IN Connection
Plug Car Charger
Into Vehicle’s Side
Power Port
Plug Car Charger
Into Right Side of Cradle
Plug Optional Hands-Free Mic
Into Upper Connector
Plug Lower Connector Into
Vehicle Audio System’s AUX IN
37069_HK_GPS910_810_eng:37069_GPS910_810_eng 04/06/08 18:26 Side 33
