Bedienungsanleitung Harman Kardon HK3390 (Seite 16 von 28) (Englisch)

502537

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

You are now ready to connect your various components to your receiver.

Before beginning, make sure that all components, including the HK 3390,

are turned completely off and their power cords are unplugged. Don’t

plug in any of the power cords until you have finished making

all of your connections.

The receiver generates heat while it is on. Select a location that leaves

several inches of space on all sides of the receiver. It is preferable to

avoid completely enclosing the receiver inside a cabinet. It is also

preferable to place components on separate shelves rather than directly

on top of the receiver. Some surface finishes are delicate. Try to select

a location with a sturdy surface finish.

Step One – Connect the Speakers

If you have not yet done so, place your speakers in the listening room

as described in the Speaker Placement section.

Connect the front left and right loudspeakers to the Speaker 1 speaker

terminals on the HK 3390. Maintain the proper polarity by always

connecting the positive and negative terminals on each speaker to the

positive and negative terminals on the receiver. You may place a second

pair of speakers in another room, or in the same room for additional

sound power, connecting those speakers to the Speaker 2 Outputs, and

maintaining polarity. Use the Speaker 1/2 Selector on the front panel

or remote to activate either or both pairs of speakers simultaneously.

See Figure 9.

Figure 9 – Speaker Connections

Step Two – Connect the Subwoofer

Connect the Subwoofer Outputs on the HK 3390 to the line-level inputs

on your subwoofer. The same full-range signal is output through both jacks.

Thus, you have the option of connecting each jack to the line-level input

on a separate subwoofer. If both pairs of main speaker outputs are in use

in different locations, you may install a separate subwoofer with each speaker

pair. If you have only one subwoofer with a single line-level input, connect

it to the right Subwoofer Output on the HK 3390. For optional auto

turn-on/turn-off control over the subwoofer, connect the Subwoofer Trigger

Output for each subwoofer to the corresponding trigger input on its

amplifier. This enables the subwoofer to turn on or off together with the

HK 3390. To further conserve energy, when the trigger connection is made,

turn the Subwoofer Link Switch on to turn the subwoofer off when the

corresponding pair of main speakers is not being used, such as during

muting, when headphones are being used, or when the speakers are turned

off using the Speaker 1/2 switch. See Figure 10. Consult the manufacturer’s

guide for the subwoofer for additional information.

Figure 10 – Subwoofer Connection

Step Three – Connect the Antennas

Connect the FM and AM antennas to their terminals. See Figure 11.

Figure 11 – Antenna Connections

Step Four – Connect the Source Components

Use the worksheets in the Appendix to note which connections you

will use for each of your source devices.

For each source, select a source input (Video 1, Video 2, Video 3, etc.).

In Table A1 in the appendix, we recommend connecting certain types of

sources to certain source inputs to make it easier to use the remote

control.

The remote is preprogrammed to operate certain Harman Kardon

components as shown in Table A1. However, you may connect any

component with analog audio and/or composite video outputs to any

source input on the HK 3390, with the exception of the Phono Inputs,

and you may use the original remote control supplied with the

component. It is not possible to reprogram the HK 3390 remote,

or to change the device type associated with any source input.

We recommend you follow the guidelines in Table A1 when connecting

various source components to the HK 3390. However, due to the

limitations in the design of the HK 3390 remote control, when using

source components manufactured by other brands, use the device’s

original remote control to operate it.

HK 3390

SUB

HK 3390

Right (Spkr 1) Right (Spkr 2) Left (Spkr 1)Left (Spkr 2)

INSTALLATION

HK1695 3390OM 6/13/08 12:12 PM Page 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon HK3390 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon HK3390

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info