Bedienungsanleitung Harman Kardon PT2500 (Seite 7 von 16) (Englisch)

502813

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Rear Panel Connections

Using the Reference Card supplied with

this manual, use this section as a quick

guide to the connections required to

install the PT2500. For complete instal-

lation and set up instructions, see pages

7-10.

¡ Phono Input: Connect the output

of a turntable or tone arm to these

jacks.

™ System Ground Terminal: To

reduce hum and noise, connect the

ground lead from your turntable or

tone arm to this terminal.

£ Aux Input: Connect the outputs

of any audio source to these jacks.

¢ CD Input: Connect the outputs of

a CD player or external D/A convert-

er to these jacks.

∞ Tape 1 Input: Connect the

PLAY/OUT jacks of an audio tape

recorder to these jacks.

§ Tape 1 Output: Connect the

RECORD/INPUT jacks of an audio

tape recorder to these jacks.

¶ Tape 2 Input: Connect the

PLAY/OUT jacks of a second audio

tape recorder to these jacks.

• Tape 2 Monitor Output: Connect

the RECORD/INPUT jacks of a sec-

ond audio tape recorder to these

jacks.

ª VCR1 A/V Inputs: Connect the

audio and video PLAY/OUT jacks of

a VCR to these jacks.

‚ VCR1 A/V Outputs: Connect the

audio and video record RECORD/IN

jacks of a VCR to these jacks.

⁄ VCR2 A/V Inputs: Connect the

audio and video PLAY/OUT jacks of

a second VCR, or another A/V

source such as a satellite receiver to

these jacks.

¤ VDP A/V Inputs: Connect the

audio and video outputs of a laser

disc or DVD player to these jacks.

‹ Video Monitor Outputs:

Connect these jacks to the video

input of a TV or video projector.

› Remote Amplifier Trigger:

Using the accessory cable supplied

with the PT2500, connect this jack to

compatible products such as the

PA5800 for automatic turn on/off

operation.

ﬁ AC Power Cord: Connect this

plug to an unswitched, wall mounted

AC outlet.

ﬂ Unswitched Accessory AC

Power Outlet: This outlet provides

AC power that may used with any AC

device up to 100 watts. The power

will remain on at this outlet regardless

of whether the PT2500 is on or off.

‡ Switched Accessory AC Power

Outlet: This outlet provides AC

power to connected products only

when the PT2500 is turned on. Note

that the total current draw of the

products may not exceed 100 watts.

° Remote Control Extension

Output: This jack may be connect-

ed to other compatible Harman

Kardon products so that they will

receive infrared commands cap-

tured by the PT2500’s remote sen-

sor.

· Remote Control Extension Input:

If the PT2500’s front panel IR sensor

is blocked due to cabinet doors or

other obstructions, an external IR

sensor may be used. Connect the

output of the sensor to this jack.

a Surround Channel Outputs:

Connect these jacks to the surround

channel inputs of a power amplifier

or digital audio processor with pass

through capability.

b Center Channel Outputs:

Connect the output of one of these

jacks to the center channel input of

a power amplifier or digital audio

processor with pass through capa-

bility.

NOTE: In most applications only one

center channel connection will be

required. The output of both jacks is

identical, and either jack may be

used for system connections.

c Front Channel Outputs:

Connect these jacks to the front

left/right channel inputs of a power

amplifier or digital audio processor

with pass through capability.

d Subwoofer Outputs: Connect

these jacks to the line level input of a

powered subwoofer, or to the inputs

of a subwoofer amplifier.

NOTE: This output is a full range

left/right signal. For proper operation

BOTH jacks must be connected to

the left/right inputs of a powered

subwoofer, or a “Y” cable must be

used to connect the two outputs

together if a single input mono sub-

woofer is used.

WARNING: Since this is a full range

output, the signal must be sent

through a crossover or low pass filter

before being used with a passive

subwoofer or other speaker that

does not contain a built in crossover.

e AM Antenna Input: Connect the

AM loop antenna supplied with the

PT2500 to these terminals. An exter-

nal AM antenna may also be con-

nected here.

f FM Antenna Input: Connect an

FM antenna to these terminals. Note

that a 300 ohm to 75 ohm adapter is

required for connections from twin

lead dipole antennas.

PT2500 rev (G) 10/23/96

•PT2500(g).qx 10/23/96 7:36 AM Page 6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon PT2500 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info