Bedienungsanleitung Harman P43-C (Seite 11 von 40) (Englisch)

815496

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2311 8390-044C

Fire Risk

DoNOToperateappliance:

• With appliance door open.

• Burnpotooropen.

• Cleaning slide plates open.

Do NOT store fuel:

• Closer than required clearances to combustibles to

appliance

• Within space required for loading or ash removal.

WARNING

E. Automatic Ignition

AdjustFeedLimit.Ifthisisyour

rstreoryouaretryingdi󰀨erent

pellets, set the feed limit to #4,

Figure 4.5 This is a conservative

number and will probably need

to be increased. After you know

a Feed Limit setting that works

well, use that setting. Remember,

if your feed rate is too high you

may waste fuel.

Setting the feed limit # for maximum burn: With the unit

burningin“AUTO”,turnto“ConstantBurn”andputthefanon

“H”. Set the Temperature Dial to #7. Allow the unit to burn for

about 30 minutes and check ash on front of burn pot. Figure

4.6. If the ash line is larger than 1”, turn the feed limit from

#4 to #5. Allow another 30 minutes of burn time and check

again. If, at #6 setting, a 1” or less ash bed is not obtainable,

itisnotaproblem.The1”ashbedisonlyatmaximumburn

rate and during normal operation, the ash bed will be larger.

Figure 4.5

Figure 4.6

Note: The rebox low pressure switch will not allow the

auger motor or the igniter element to operate if the view

door is open.

Igniter Switch to "AUTO" (up position)

Make sure the unit is plugged into a properly grounded, 120

VAC, 60 Hz electrical source. The power light should be the

only light lit.

Note: Be sure there is no fuel or other combustibles in

the ash pan prior to lighting.

1. TurnModeSelectorto"OFF".

2. Fill hopper with pellets.

3. Clean burn pot with scraper, if necessary.

4. If starting after an empty hopper, turn Feed Limit to "TEST"

(forone60secondcycle).Thiswillowpelletsintothe

auger tube and also allow you to check the motors for

operation.

NOTE: The auger motor will not operate with the view

door open.

5. Turn Feed Limit to #4.

6. FliptheIgniterSwitchupintothe"AUTO"position.

7. Turn the Temperature Dial to the desired room temperature.

8. Turn Mode Selector to Room Temperature or Constant

Burn mode.

9. Fill hopper with pellets and remove ashes as required.

Keep the hopper lid and rebox doors closed while in

operation. Maintain door seals in good condition. Failure

todosowilla󰀨ectoperationoftheapplianceandmay

permit escape of smoke or gases into the living space

causing smoke detectors to sound.

BURNING GARBAGE, USE OF IMPROPER FUELS,

FIRESTARTERS OR ALTERING THE STOVE FOR

HIGHER HEAT OUTPUT MAY CAUSE DAMAGE TO

THE STOVE AND COULD RESULT IN A HOUSE FIRE.

USE ONLY APPROVED FUELS AND FOLLOW ONLY

THESE OPERATION GUIDELINES.

WARNING

NEVER USE GASOLINE, GASOLINE-TYPE LANTERN

FUEL, KEROSENE, CHARCOAL LIGHTER FLUID,

OR SIMILAR LIQUIDS TO START OR 'FRESHEN UP'

A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS

WELL AWAY FROM THE HEATER, WHILE IN USE.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman P43-C Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman P43-C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info