Bedienungsanleitung Harman P43-C (Seite 23 von 40) (Englisch)

815496

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2323 8390-044C

C. Loss of Power

Harman pellet burning appliances rely on a combustion

blowertoremoveexhaustfromtherebox.Apowerfailure

will cause the combustion blower to stop running, which

mayleadtoexhaustseepageintotheroom.Verticalrisein

the venting system can help create natural draft, which may

reducethelikelihoodofexhaustleakageintothehome.

Installationofalow-costuninterruptiblepowersupply(UPS)

or battery backup system can help ensure the units shuts

down without any minor smoke leakage into the home.

Harman recommends the installation of one of these two

systems for areas prone to power outages.

There is one Harman® approved UPS option for your

appliance:

Uninterruptible Power Supply UPSbatteryback-upsare

availableonlineoratcomputerando󰀩ceequipmentstores.

Your Harman® appliance with Rev E or later software

available beginning in November 2010 may be plugged

directly into a Harman® approved UPS:

• TrippLite model INTERNET750U is tested and

approved. Other brands or models may not be

compatible.

When power is lost, a fully charged UPS will power a safe,

combustion blower only shut-down. Your appliance will

pulsetheblowereveryfewsecondstoclearexhaustuntil

thereisout. NOTE: The UPS provides safe shut-down

only. It is not intended for continued operation.

• A Inverter/Charger connects to a 12 volt deep cycle

battery that will run your appliance for up to eight (8)

hours. It includes a trickle charge feature that keeps your

battery charged when power is available. NOTE: If the

power is out for longer than battery life, smoke leakage

may still occur unless your stove has been safely shut

down.

For an approved Inverter/Charger refer to www.

harmanstoves.com.

Your appliance will recognize when power is restored. What

happens depends on ESP temperature and whether it is

equipped with automatic ignition:

• In “Automatic” Mode, units equipped with automatic

ignition will respond to the set point and ESP temperature

and resume normal operation.

• In “Idle” Mode, or for units without automatic ignition:

• If the ESP is cool, the appliance will remain shut

down.

• IfthereisoutandtheESPisstillwarm,thefeeder

mayrestart.Sincethereisout,theESPtemperature

willnotrise.Theunitwillthenshut-down,andmay

ashasix-blinkstatuserror.(SeeESPerrorcodes)

• If the re is still burning, it will resume normal

operation.

Contact your dealer if you have questions about UPS

compatibility with your appliance.

IMPORTANT! : UPS or Battery Backup cannot prevent smoke

leakage from an improperly maintained unit. Keep the venting

system clean and free from obstructions and maintain all

gaskets to keep an airtight seal.

Use only Harman® approved battery back-up devices.

Other products may not operate properly, can create

unsafe conditions or damage your appliance.

CAUTION

Always keep appliance doors and hopper lid closed

and latched during operation and during power

failures to minimize risk of smoke or burn-back.

D. Emergency Manual Ignition

Harman® pellet stoves and inserts should be lit using the

automatic ignition system. This is the safest and most

reliable way for igniting the unit. In the event the automatic

igniter is not functioning, the steps below may be followed

to manually light the stove or insert in the “Constant Burn”

mode. Manual lighting is for emergency purposes only,

and the igniter should be repaired or replaced as soon as

practical.

WARNING

Only use restarter commercially marketed for pellet

stoves and inserts, including wax coated wood chips,

pellet starter gel and pellet igniter blocks. Use of any

othertypeofrestarterisprohibited.

To avoid serious injury or death read and follow

manufacturer’swarningandinstructionsforuseofrestarter.

Useofrestarterisonlypermittedwhenperformingacold

start.

Never attempt to manually light a stove or insert that has

been operated recently and is not at room temperature.

If automatic ignition was attempted, be sure to give the

stove or insert at least 30 minutes or longer to cool to room

temperature.

Besurethatthestoveorinsertisinthe“Igniter-Disabled”

mode of operation.

Once all the precautions have been taken, follow these

steps:

1.TurntheModeSelectorto“OFF”.

2.Fillburnpotwithpellets,onlyhalfway.(DoNotOverFill).

3. Add firestarter to pellets following manufacturer’s

instructions.

4. Light pellet gel with a match, and close the door, turn Mode

SelectortoConstantBurn.Operationwillbeginwhenthe

rereachesthepropertemperature.

WARNING

Harman P43-C Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman P43-C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info