Bedienungsanleitung Harman P61-C (Seite 12 von 40) (Englisch)

815497

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2312 8390-044C

TheP-SeriesPelletStoveismorethanjustautomaticignition,

it is also automatic temperature control. The automatic

systemwillallowtheresizetobeadjustedtomatchthe

heatingneedsandevenputthereoutifnecessary.Ifheat

isneededafterthereisout,theP-SeriesPelletStovewill

automaticallyre-igniteandadjusttheresizetomatchthe

heating need. The totally automatic room sensor mode is

recommended because of its e󰀩ciency. The unit can be

switched between "AUTO" and "DISABLED" at any time

during operation.

Igniter switch to “AUTO”

Room Temperature Mode

In “Room Temp Mode” heat output is controlled automatically

by the Room Sensing Probe. When the Room Sensing Probe

calls for heat, the stove will increase output. When the Room

Sensing Probe is getting close to the set temperature, the

stovewillbegintolevelo󰀨outputandkeepthereburning

atjusttherighttemperaturetomaintainthatsetting.

High output is determined by the Feed Limit setting. This

setting, generally on #4, can be increased if higher burn rates

arenecessary(Figure4.6).Theunit’smaximumburnrate

should not create less than 1” of ash on the burn pot front

edge(Figure4.7).Overfeedingisnotasafetyconcern,but

fuel may be wasted if unburned pellets fall into the ash pan.

In “Room Temp Mode” a constant fuel consumption rate is

sacricedforexactroomtemperature.Therefore,asitgets

colder more pellets will be burned automatically.

The distribution blower speed will vary according to the

positionofthemodeselectorpointer,andresize.

Igniter switch to “AUTO”

Constant Burn Mode

Thisallowsforautomaticignitionuponstart-uponly.Theunit

can then be set at any desired setting. The heat output and

fuel consumption will remain constant regardless of room

temperature.Theunit’smaximumfeedrateshouldnotcreate

less than 1” of ash on the burn pot front edge. Figure 4.7.

The unit’s low burn or maintenance setting is as low as it will

go.Itwillnotgooutunlessitrunsoutoffueloristurnedo󰀨.

Shut-Down Procedure

To kill the re or stop burning the stove, turn the Mode

Selectorto“OFF”.Thiswillcausetheretodiminish and

burnout.Whenthereburnsoutandthestovecoolsdown

everything will stop.

If you pull the plug to shut down the stove, all motors will stop.

This may cause incomplete combustion and smoke in the

rebox.Iftheloaddoorisopened,thesmokemayescape.

The best way to shut down the stove is simply let it run out

of pellets, then the stove will shut down automatically.

Room Temperature Mode: This setting will produce a room temperature

of 70 degrees with the distribution blower at medium speed.

This setting will produce medium heat with the distribution

blower on "low".

This setting will produce continuous maximum heat output with

the distribution blower at full speed.

Constant burn Mode

E. Automatic Ignition (Continued)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman P61-C Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman P61-C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info