Bedienungsanleitung Harman P68-C (Seite 10 von 40) (Englisch)

815498

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2310 8390-044C

B. Fire Characteristics

Aproperlyadjustedrehasamediumactiveamepattern

that extends out of the burn pot approximately 6 inches

(152mm).

C. Feed Limit Instructions

The Feed Limit control is factory set at #4, and should be

adequate for most fuels.

However, if the flame height is too high or too low, you will

needtoadjusttheFeedLimit. Wait until the appliance has

been burning for 15 minutesbeforemakingyouradjustments

and a

llow15minutesforfeedadjustmenttotakee󰀨ect.

A. Starting Your First Fire

1. A room sensor is required for proper operation of this

appliance in “Room Temp” mode. At this time, ll the

hopper with pellets, insure the control is set to “OFF”.

Figure 4.1. Plug the power cord into a properly grounded,

nearby outlet.

2. Oncepowerispresent,theunititwillrunthroughaquick

diagnostics test to insure the control is operating properly.

This is normal.

3. Foryourrstreitmaybenecessarytopurgetheauger

system by putting the feed limit knob to “Test” prior to

starting the unit. Figure 4.2. This insures that plenty of

fuel enters the burn pot for proper ignition.

4. Flip toggle switch to desired mode “Auto or Disabled”.

Figure 4.3. Set feed limit knob to desired setting and turn

mode dial to “Room Temp” or “Constant burn” Figure 4.4.

Note:Feedrateof#4isagoodstartingpoint.Adjustments

may need to be made depending on fuel quality and/or

heat output desired.

The fuel feed system and the igniter should

now

be on.

6. Oncetheappliancehasignited,letitburnforapproximately

7-10minutes.Afterthistime,theigniterlightshouldturn

o󰀨andtheunitshouldbegintooperateperthesettings

at the control.

Figure 4.1 Figure 4.2

Figure 4.4Figure 4.3

4 4 Operating Instructions

Odorsandvaporsreleasedduringinitialoperation.

• Curing of high temperature paint.

• Openwindowsforaircirculation.

Odorsmaybeirritatingtosensitiveindividuals.

CAUTION

D. Ignition Cycles

1. At the beginning of each ignition cycle, it is normal to see

somesmokeintherebox.Thesmokewillstoponcethe

restarts.

2. The distribution blower will automatically turn on after your

appliance has reached the set temperature.

This blower transfers heat from your appliance into the

room, and will continue to run in “constant burn” mode

at the set speed you have the control knob at. In “room

temp” mode however, the blower will turn on and o󰀨

in accordance to what temperature the room sensor is

reading.Whentheroomsensorissatisedtheblowerwill

shut down until the room sensor sees a demand for heat.

3. Occasionallytheappliancemayrunoutoffuelandshut

itself down. When this happens, the unit will need to be

turnedtotheo󰀨positionandrestarted.

If needed, follow the instructions in Section A “Starting

Your First Fire”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman P68-C Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman P68-C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info