801892
29
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 12 of 16 AquaRite® Pro LS Rev. D
INSTALLATION
Installation must be performed in accordance with Local codes.
230 V / 50Hz
POWER
LINE LOAD
ELECTRICAL
BOX
FILTER
PUMP
SOLAR
SYSTEM
HEATER
or
HEAT
PUMP
FROM
POOL
FROM
SPA
TO
POOL
TO
SPA
ELECTROLYTIC
CELL
FLOW
SWITCH
IN-FLOOR
CLEANER
Preparing Pool Water
Refer to page 4 for recommended chemical levels. The pool's chemistry must be balanced BEFORE activating the
AquaRite Pro LS. NOTE: If the pool does not have new water, add 1 liter of metal remover and 1 liter of non-copper
based algaecide to the pool, per manufacturer's instructions. This ensures a quick, troublefree transfer to the AquaRite
Pro LS system.
Mounting the AquaRite Pro LS Control
The AquaRite Pro LS is contained in a raintight enclosure that is suitable for outdoor mounting. The control must be
mounted a minimum 3.5 meters horizontal distance (or more, if local codes require) from the pool/spa.
The control is designed to mount horizontally on a flat surface with the knockouts facing downward. Because the
enclosure also acts as a heat sink (disperses heat from inside the box), it is important not to block the four sides of the
control. Do not mount AquaRite Pro LS inside a panel or tight enclosed area.
If an AQL-CHEM kit will be used, take into consideration the space necessary for mounting the unit as well as running
the plumbing lines from the AQL-CHEM's probe cell to the pool plumbing. Refer to the AQL-CHEM manual for specific
mounting instructions.
Plumbing
Ensure that the AquaRite Pro LS installation does not constitute a cross connection with the local potable water supply.
Consult local plumbing codes.
The AquaRite Pro LS is packaged with a flow switch that installs into the supplied 50 mm saddle clamp. The chlorinator
cell, sold separately, installs into the supplied 50 mm cell unions.
The flow switch and cell should be plumbed in the return line to the pool/spa. The preferred installation is after
(downstream) all the pool equipment (filter, heater, solar, etc.). For proper plumbing, refer to the overview diagram above.
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hayward Aqua Rite Pro LS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info