Bedienungsanleitung Hayward Aqua Rite Pro (Seite 25 von 177) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

801911

Zoom out

Zoom in

Vorherige Seite

1/177

Nächste Seite

1 / 20 AquaRite Pro Rev. C

OPERATION

The AquaRite Pro is an automatic chlorine generation system for pool or spa sanitization. The

operation requires a low concentration of salt (sodium chloride) in the pool water. These levels

are low enough that it normally will not be tasted. The AquaRite Pro automatically sanitizes

your pool by converting the salt into free chlorine which kills bacteria and algae in the pool.

Chlorine will revert back to sodium chloride after killing bacteria. These reactions will continu-

ously recycle virtually eliminating the need to add sanitizing chemicals to your pool. The only

time you may need to add more salt to the pool is when water is replenished due to backwashing,

draining, or splashing (not evaporation).



pools up to 150 m3, or the needs of most commercial pools up to 95 m3. Check local codes for

other restrictions. The actual amount of chlorination required to properly sanitize a pool varies

due to bather load, rainfall, temperature, and the pool's cleanliness.

AquaRite Pro chlorine generators operating with software version 1.00 or later are designed to

use one of 3 different chlorinator cells that are available from your authorized Hayward dealer.

Choose the appropriate cell based on the size of your pool. The models are shown below:

T-CELL-15-E - for pools up to 150 m3

T-CELL-9-E - for pools up to 95 m3

T-CELL-3-E - for pools up to 60 m3

Note that the installation and mounting requirements are the same for all models.

The AquaRite Pro can be used with the optional Goldline AQL-CHEM to provide a fully in-

tegrated chemistry solution for your pool. With the AQL-CHEM installed, the AquaRite Pro

senses the pool's ORP and pH levels and automatically generates the correct amount of chlorine

to keep your pool properly sanitized. The AquaRite Pro can also control pH by introducing acid

into the pool when needed. A dedicated on/off control output is available for pH dispensing

devices using 230 V



. The AquaRite Pro and AQL-CHEM products offer the user a complete

automated system controlling both sanitization and pH balance.

NOTE: It is not recommended to use the AquaRite Pro to generate bromine.





installation specialist should be consulted regarding the appropriate type, installation, sealant

(if any) and maintenance of stone used around a saline pool with electronic chlorine generator

in your particular location and circumstances.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hayward Aqua Rite Pro Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info