Bedienungsanleitung Hayward Aqua Rite Pro (Seite 36 von 177) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

801911

Zoom out

Zoom in

Vorherige Seite

1/177

Nächste Seite

12 / 20 AquaRite Pro Rev. C

stop growing at this temperature. You can override this low temperature cutoff by using the

Super Chlorinate function for a day.

Prevent overchlorination during cold weather: Check chlorine levels periodically. Most pools

require less chlorine during cold weather and the desired output % setting should be lowered

accordingly.

Maintaining the AquaRite Pro System

To maintain maximum performance, it is recommended that you open and visually inspect the



by displaying the message “Inspect/Clean Cell” after approximately 500 hours of operation.

The AquaRite Pro electrolytic cell has a self cleaning feature incorporated into the electronic

control’s logic. In most cases this self cleaning action will keep the cell working at optimum



chemistry has been allowed to get "out of balance", the cell may require periodic cleaning.

Servicing and Cleaning the AquaRite Pro Cell

Turn off power to the AquaRite Pro before removing the electrolytic cell. Once removed, look







off. If this is not successful, use a plastic or wood tool (do not use metal as this will scratch the

coating off the plates) and scrape deposits off of plates. Note that a buildup on the cell indicates

that there is an unusually high calcium level in the pool (old pool water is usually the cause). If

this is not corrected, you may to have to periodically clean the cell. The simplest way to avoid



Mild Acid Washing:

majority of deposits. To acid wash, turn off power to AquaRite Pro. Remove cell from piping.

In a clean plastic container, mix a solution of water to acetic or phosphoric acid (Like descaler

for coffee machine). ALWAYS ADD ACID TO WATER - NEVER ADD WATER TO ACID.



container should just reach the top of the cell so that the wire harness compartment is NOT

submerged. It may be helpful to coil the wiring before immersing the cell. The cell should

soak for a few minutes and then rinse with a high pressure garden hose. If any deposits are still

visible, repeat soaking and rinsing. Replace cell and inspect again periodically.

Winterizing

           

water just as your pool plumbing would. In areas of the country which experience severe or



supply and return lines before any freezing conditions occur. The electronic control is capable

of withstanding any winter weather and should not be removed.

Spring Start-up

DO NOT turn the AquaRite Pro on, until the pool water chemistry has been brought to the proper

levels. This information can be found on page 2

Hayward Aqua Rite Pro Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info