Bedienungsanleitung Heco Victa 601 (Seite 7 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

583214

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Dear HECO Customer,

Congratulations onyour fine newloudspeakers and thankyou very muchfor choosing HECO!Youhave

madeanexcellentchoice.Thehigh-qualityspeakersproducedbyHECOarerenownedallovertheworld.

Please study theinstructions and informationbelow carefully beforeusing your newloudspeakers.

GENERAL INFORMATION ABOUT CONNECTING YOUR HECO VICTA LOUD-SPEAKERS

Please always use a good quality loudspeaker connection cable from an audio dealer. To prevent

impairmentofsoundquality,werecommend cableswithcross-sections ofatleast 2.5mm²for lengthsup

to 3 mand at least4 mm²for lengths above3 m.

Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables. Place

the loudspeakers in their planned positions and cut the cables to the right length. The cables for both

channels should alwaysbe exactly thesame length.

Strip10–15mmofinsulationfromtheendsofthecables.Twisttheends–thisismuchbetterthantinning

them with solder– insert themin the terminalsand tightenthe terminal screwsfirmly. (Fig.1)

For good sound it is imperative that the cables must be connected in such a way that the speakers are

“in phase”. This means that the black negative terminals on the speakers (-) must be connected to the

negative (-) terminals on the amplifier, the red positive (+) speakerterminals to the positive (+) amplifier

terminals.Tomake thiseasierone wireof mostspeaker cablesismarked witha colouredstrip oraridge

in the insulation.

Beforeswitchingonthesystemdouble-checkallyourconnectionsandmakesurethattheterminalscrews

are tight and that there are no short circuits caused by stray wire filaments – this could cause serious

damage to youramplifier!

THE HECO VICTA LOUDSPEAKERS IN STEREO MODE

Intheidealconfigurationthespeakersandthelisteningpositionshouldformanequilateraltriangle.When

theleftandrightspeakersarethesamedistancefromthelisteningpositiontheirsoundarrivesatthesame

time, resulting ina harmonious, naturalmusic reproduction. (Fig.2)

There should be a clear line of sight between the loudspeakers and the listening position. Any sound-

absorbingorreflectingobstaclesin thepath willdistort thesound. Whenyou install theloudspeakers the

following distancesshould be maintained:

Victa floorstanders:at least20 cmaway from therear walland atleast 30cm from theside walls.This

will prevent excessiveemphasis of thebass range.

Victa bookshelf speakers: shelfloudspeakersshouldalsobeasfree-standingaspossible,thedistance

to the sides and rear to walls and items should be at least 10 cm, the tweeters should be located at ear

height.

Spikes (Victa floorstanders): you should use the supplied spikes when setting the speakers up. This

isolates them from the supporting surface, preventing unpleasant resonance effects. You can choose

between metal and hard rubber spikes for the standing speakers. The spikes are screwed into the

threaded bushes onthe bottom ofthe speaker.

HECO VICTA LOUDSPEAKERS AS A FRONT OR REAR LOUDSPEAKER

Thefrontloudspeakers arepositionedatearheight ontheleftand rightasequidistantfromthetelevision

as possible.The rearloudspeakers areplacedat earheight ora little aboveon the left and rightbesides

or better behindthe listening position.(Fig. 3)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Heco Victa 601 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info