Bedienungsanleitung Hema 80010105 (Seite 6 von 35) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

750657

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

- 5 -

80.01.0105 EN

TECHNICAL DATA

Operating voltage: 220-240V ~ 50/60Hz

Power consumption: 1850-2200W

HOUSEHOLD USE ONLY

PARTS DESCRIPTION

1. Lid release lock

2. On/Off Switch

3. Handle

4. Water Gauge

5. Indicator light

6. Power Base

7. Anti-calc filter

BEFORE USING YOUR KETTLE

If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling

a full kettle of water twice and then discarding the water.

OPERATION OF YOUR KETTLE

1. Open the lid; fill with the desired amount of water to the water kettle. Always fill the kettle between the

minimum (0.5L) and maximum (1.7L) marks. Too little water will result in the kettle switching off before the

water has boiled.

NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.

Ensure that the lid is firmly in place before connecting the power cord to the outlet.

This water kettle is equipped with an overfill safety feature. This will make sure that in case of overfilling

the kettle the water will not come in contact with electrical components of the kettle ensuring no unsafe

situations can occur. In case of overfill the water will be lead through the inner side of the kettle and will

exit the kettle at the bottom, away from the electrical element.

2. Connect the plug into a power outlet. Press the On/Off Switch button to position “I” on the handle and the

kettle starts to boil the water. The indicator light will light up. The kettle will switch off automatically once

the water has boiled. You can shut off the power by pressing the switch button to position “O” at any

moment during boiling water.

NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed. The kettle will not turn off if

the switch is constrained or the lid hasn’t been closed.

3. Take the plug out of the outlet. Lift the kettle, then pour the water.

NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.

4. The kettle will not re-boil until the switch is pressed again. Allow the kettle to cool down for 30~40 seconds

before reopening to boil water.

NOTE: Ensure power supply is turned off when kettle is not in use.

5. Should you accidentally allow the kettle to operate without water, the boil-dry protection will automatically

switch it off. If this occurs, allow the kettle to cool down before filling with cold water and re-boiling.

CLEANING AND MAINTENANCE

1. Always let the kettle cool down first and disconnect the appliance from the power outlet before cleaning.

2. Never immerse the kettle area or cord in water, or allow moisture to contact with these parts.

3. To clean the filter: unlock the lid and pull out the filter. Rinse the filter with running water and then dry it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hema 80010105 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info