Bedienungsanleitung Hema 80080012 (Seite 20 von 37) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

775845

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

- 19 -

HOUSEHOLD USE ONLY

PARTS DESCRIPTION

1. Lid

2. Handle

3. Water gauge

4. On/off switch

5. Power base

6. Water inlet

7. Filter

8. Power cord and plug

BEFORE USING YOUR KETTLE

If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling

a full kettle of water twice and then discarding the water.

OPERATION OF YOUR KETTLE

1. Pour out left over water from previous boiling cycle and fill with the desired amount of fresh water to the

water kettle. Make water directly run through the water inlet at the center of the lid (the strong water

flow can push the cover of the water inlet to open automatically), or open the lid and fill with the desired

amount of water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum

(1.5L) marks. Too little water will result in the kettle switching off before the water has boiled.

NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.

Ensure that the lid is firmly in place before connecting the power cord to the outlet.

2. Connect the plug into a power outlet. Press the On/Off switch downwards. The kettle starts to boil the

water. The LED light will be shining in blue. The kettle will switch off automatically once the water has

boiled. You can shut off the power by pressing the switch upwards at any moment during boiling water.

NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed all the time throughout the

boiling cycle. The kettle will not turn off if the switch is constrained and scalding may occur if the lid is

open.

3. Take the plug out of the outlet. Lift the kettle then pour the water.

NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.

4. The kettle will not re-boil until the switch is pressed again. Allow to cool for 30~40 seconds before

reopening to boil water. Never re-boil water older than 2 hours.

NOTE: Ensure power supply is turned off when kettle is not in use.

5. Should you accidentally allow the kettle to operate without water; the boil-dry protection will

automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and

re-boiling.

CLEANING AND MAINTENANCE

1. Always let the kettle cool down first and disconnect the appliance from the power outlet before cleaning.

2. Never immerse the kettle area or cord in water, or allow moisture to contact with these parts.

3. To clean the filter: open the lid; rinse the filter with running water and then dry it.

Cleaning appearance of housing:

Wipe the appearance of body with a mild and damp cloth or cleaner, never use a poisonous cleaner.

Never immerse the power base in water or other liquid for cleaning.

Descale regularly, preferably at least once a month and more frequently if your water is very hard.

To descale your kettle, use:

• white vinegar

- fill the kettle with half a litre of vinegar

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hema 80080012 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info