Bedienungsanleitung Hendi 223352 (Seite 13 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

741898

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

2. TESTING

The oven should be tested by carrying out a trial cooking session to check that the appliance is working prop-

erly and that there are no problems or malfunctioning. Set the temperature controller at 150° C and the timer

to 10 minutes.

Check every item in the list below:

• The coking chamber light is ON.

• The oven stops (heating, humidiﬁcation, motors/fans) when the door is opened and resumes operating when

the door is closed again. (This only for models with inverter gear)

• On reaching the set temperature, the cooking temperature thermostat turns off the heating elements.

• The fans automatically invert the direction of rotation; the inversion occurs every 2 minutes. Humidiﬁcation

turns off brieﬂy for 20 seconds when the machine is stopped (This only for models with inverter gear)

• The cooking chamber fans spin in the same direction.

• If the oven is equipped with a humidity controller, after using button to activate it, check that water is being

discharged to the fan from the humidity inlet duct in the oven chamber

CLEANING

FIRST CLEANING OF THE COOKING CHAMBER OF THE OVEN

Disconnect electrical power from the appliance and wait until the oven is cooled completely before clean-

ing.

There should never be any residue of solvents or detergents. They should be removed by rinsing thoroughly

using a damp cloth. Appropriate eye, mouth and hand protection should be used. Possible danger of corrosion.

Heat the oven empty up to 200° C (392° F) for about 30 minutes so as to eliminate thermal insulation odors.

Clean the walls of the cooking chamber using hot water and soap, then rinse; never use aggressive or acid

products

3. ORDINARY MAINTENANCE

The user is solely responsible for ordinary maintenance. The Assistence Centre must be contacted for extraor-

dinary maintenance which requires a specialized authorized technician.

Before cleaning, disconnect the device from the power supply and wait until it is fully cold.

ATTENTION: never clean the device with water jet of pressurised vapour.

ORDINARY CLEANING OF COOKING CHAMBER

At the end of a working day, clean the equipment, both for hygienic reasons and to avoid malfunctioning.

The oven must never be cleaned using direct or high pressure water jets. In the same manner, to clean the

applian¬ce do not use pan-scrubbers, steel brushes or scrapers; it is possible to use stainless steel wool,

rubbing it in the direction of the sheets satin ﬁnish

For manual cleaning follow the procedure below:

• Turn on the appliance and set the temperature to 80°C.

• Leave it on for 10 minutes on steam

• Turn off the appliance and let it cool down

• Remove the side tray racks. Manually remove all removable residues place the removable parts inside

dishwashers.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 223352 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info