Bedienungsanleitung Hendi 225165 (Seite 7 von 112) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

741834

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

4.4 CONNECTION OF POWER CABLE

The terminal board is on the rear panel of the ap-

pliance. Open the terminal board cover by obtain-

ing leverage with a screwdriver on the two side ﬁ ns.

Loosen the cable gripper screw and allow the cable

to pass through it. Arrange the conductors so that

the earth conductor is the last to detach from its

terminal if the cable goes into a state of faulty trac-

tion. Connect the phase conductor to the terminal

marked with the letter “L”, the neutral conductor

to the terminal marked with the letter “N” and the

earth conductor to the terminal marked with the

symbol . Tighten the ring-nut of the cable gripper

and close the terminal board cover. The appliance

must be connected to an equipotential system

whose efﬁ ciency must ﬁ rst be checked according

to current legal regulations. This connection must

be made between different appliances by using the

appropriate terminal marked with the symbol .

The equipotential conductor must have a minimum

diameter of 2,5 mm

. The equipotential terminal is

at the rear of the appliance.

230V

L2 L1 N

400V / 2N

L2 L1

4.5 SAFETY THERMAL BREAKER

The appliance has safety thermal breaker. It pro-

tects against excessive dangerous over-tempera-

tures which could be accidentally generated inside

the appliance. If the device is tripped, it interrupts

electrical power to the appliance and thus prevents

it from operating.

5. USE INSTRUCTIONS (FOR THE USER)

This appliance is not intended for use by persons

(including children) with reduced phycal, sensory

or mental capabilities, or lack of experience and

knowledge. Unless they have beengiven supervi-

sion or instruction concerning use of appliance by

a person responsible for their safety.

Children should be supervised to ensure that they

do not play with the appliance.

For ﬁ rst use, we advise you to let the appliance to

run load-free at maximum temperature for about

one hour. In this way, any unpleasant smells due

to thermal insulation and residual work grease are

eliminated.

This appliance must be used solely for the purpose

for which it was expressly designed, i.e. cooking

foods in the oven. Any other use is considered un-

suitable.

The appliance can be used: for all oven cooking of

deserts, pizzas, meat, ﬁ sh, vegetables, as well as

for gratinating, and for re-conditioning cooled and

frozen foods.

When placing food in the cooking compartment,

leave a space of at least 40 mm between pans in

order not to over-obstruct air circulation.

Do not use pans with higher than necessary edges:

edges are barriers which prevent the circulation of

hot air.

Warm up the oven before every cooking operation

to obtain maximum uniformity.

Do not salt foods in the cooking compartment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 225165 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info