Bedienungsanleitung Hendi 272404 (Seite 14 von 178) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

742604

Zoom out

Zoom in

Vorherige Seite

1/178

Nächste Seite

Storage

There is no limitation on the storage of the appli-

ance indoors provided that the cylinder is removed

from the appliance.

Between uses:

• Turn control knob OFF.

• Turn gas cylinder OFF.

Store heater upright in an area sheltered from di-

rect contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

If desired, cover to protect exterior surfaces and to

prevent build up in air passages.

Note: Wait until heater is cool before covering.

During periods of extended inactivity or when

transporting:

• Turn control knob OFF.

• Disconnect gas cylinder and move to a secure,

well ventilated location outdoors. DO NOT store

in a location that will exceed 50°C.

Store heater upright in an area sheltered from di-

rect contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

If desired, cover heater to protect exterior surfaces

and to prevent build up in air passages.

Note: Wait until heater is cool before covering

Troubleshooting

IF THE PROBLEM IS AND THIS CONDITION EXISTS THEN DO THIS

Pilot won’t light

Cylinder valve is closed Open valve

Blockage in oriﬁce or pilot tube Clean or replace oriﬁce or pilot tube

Air in the gas line

Open gas line and bleed it (pressing control knob in)

for not more than 1-2 minutes or until you smell gas

Low gas pressure

Replace propane gas (disposable) cylinder with a

new cylinder

Igniter fails

Use match to light pilot (with match holder, see

picture**); obtain new igniter and replace

Pilot won’t stay lit

Dirt build up around pilot Clean dirt from around pilot

Connection between gas valve and pilot

assembly is loose

Tighten connection and perform leak test

Thermocouple is not operating

correctly

Replace thermocouple

Burner won’t light

Gas pressure is low

Replace propane gas (disposable) cylinder with a

new cylinder

Blockage in oriﬁce Clear blockage

Control knob is not in "ON" position Turn control knob to "ON" position

Burner ﬂame is low

Note: Do not operate heat

er below 5°C (40°F)

Gas pressure is low Replace gas cylinder

Outdoor temperature is greater than 5°C

(40°F) and tank is less than 25% full

Replace gas cylinder

Supply hose is bent or kinked Straighten hose and perform leak test on hose

Control knob is fully " ON"

Turn control knob to "OFF", let it cool to room tem

perature and check burner and oriﬁces for blockage

Emitter glows uneven

Note: Bottom 2.5cm of

emitter normally does not

normally glow

Gas pressure is low Replace gas cylinder

Base is not on a level surface Place heater on a level surface

Heater not level Level heater

Carbon build-up Dirt or ﬁlm on reﬂector and emitter Clean reﬂector and emitter

Thick black smoke Blockage in burner

Turn control knob to "OFF", let it cool to room temper

ature and remove blockage and clean burner inside

and outside.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 272404 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info