Bedienungsanleitung Hendi 273876 (Seite 6 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

741687

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Instruction for installation

Attention: Make sure again all the electrical power

system circuit is CLOSED and the switch (5) of the

appliance is at the OFF (0) position.

A) Installation of the mounting bracket with hook

(Not included).

• Secure the mounting bracket with screws and

wall anchors provided.

• Feed the electrical wires from the ceiling through

opening of the mounting bracket.

B) Assemble the appliance with the hook.

• You can extend the power cord by twisting the cap

cover (4) if the internal wires of power cord (1) are

too short for connection.

• Please make sure the wires are connected to the

corresponding wires terminal of the power circuit

system. The wires of the power cord are coloured

as below:

a) Blue = Neutral (N)

b) Brown = Live (L)

c) Green and yellow = Earth (E)

• Wrap the connected wires together with the elec-

trical insulation tape or wiring nuts (Both are not

included).

• Hang the hole (1) of the aplliance with the hook

as provided on the mounting bracket. (Not sup-

plied).

Important: Please make sure the appliance is se-

cure and correctly connected after installation.

Operation

Attention: Make sure the electrical power system

circuit of ceiling is CLOSED and switch OFF the

hanging lamp at the “0” position.

• First, screw in clockwise direction the shatter-

proof lamp (supplied) securely inside the lamp

holder.

• This appliance has a retractable power cord to

about 150 cm that allows the lamp height to be

adjusted. Rotate the knob (3) to set the length of

the power cord as desired.

• Then, pull gently straight down on the shade

to extend the cord until the desired height is

reached.

• Next, open the electrical power system circuit

and switch ON the appliance by pressing the

switch (5) to the “I” position.

• Now, the lamp is light up and keep food warm

process is started.

•

CAUTION! HOT SURFACE! The lamp shade

(6) surface is very hot during use. Do not

touch it. Switch OFF the lamp & cool down

before setting the cord length.

Important: Remember to keep at least 0,3m dis-

tance from the lighted bulb.

Cleaning and Maintenance

Attention: Shut OFF the electrical power circuit

system, switch OFF the hanging lamp to the “0”

position and let it cool down completely before

cleaning & storage.

Cleaning

• Clean the appliance before ﬁrst use and regularly.

• Never immerse the appliance in water or other

liquids.

• Do not clean the appliance with a water jet or di-

rect washing under water.

• Clean the surface with a slightly damp cloth or

sponge with some mild soap solution

• Never use abrasive sponges or detergents, steel

wool or metallic utensils to clean the interior or

exterior parts of the appliance.

• Make sure the hanging lamp has been cleaned

and dried before further use.

Storage

• Before storage, always make sure the appliance

has already been disconnected and cooled down

completely.

• Store the appliance in a cool, clean and dry place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 273876 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info