700132
19
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
19
ELECTRICAL INTERCONNECTION
INSTALLATION INSTRUCTIONS
WARNING The amplier BRX12000D has due to construction-conditioned reasons no internal fuse-protection. The amplier must neces-
sarily be fused with an external In-Line-Fuse.
The fuse rating always depends on the total impedance. Please refer to our recommended fuse ratings on page 26.
IMPORTANT NOTE
4
1
2
3
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufcient prole section
(at least 35 mm
2
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are xed tight after
the installation, because loose connections cause malfunctions, insufcient power supply or interferences. The BRX12000D amplier has
two ground and +12V two battery terminals, which due to the high output power all must be connected.
LOGO
This push button switches the logo illumination on the upper side from blue to white.
GND
Connect both GROUND terminals with a suitable contact ground point on the vehicle’s chassis. The ground wires must be as
short as possible and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground point has a
stable and safe electric connection to the negative “–”pole of the battery. Check this ground wire from the battery to the ground
point if possible and enforce it if required. Use ground wires with a sufcient cross section (at least 2 x 35 mm
2
) and the same
size like the plus (+12V) power supply wires.
REM
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplier. Use therefor a suitable cable with a sufcient cross section (0,5 mm
2
). Hereby the amplier turns on or off with your
head unit.
BATT+12V
Connect all BATT+12V-terminals with the +12V pole of the vehicle’s battery. Use suitable cables with a sufcient cross section
(at least 2 x 35 mm
2
) and install additional in-line fuses for each cable. For safety reasons the distance between the fuseblock
and the battery should be shorter than 30 cm. Do not set in the fuses into the fuseblock until the installation is accomplished.
1 12 23 4
PROTECT
POWER
SLAVEMASTER
LP
LEVEL
BASS LEVEL
CONTROLLER
0dB 18dB
LINE IN SLAVE IN/OUT
MODE
35Hz 250Hz
L
R
MIN MAX
SUB
BOOST
Q-CONTROLPHASE
FREQ.
RANGE
SUB SONIC
15Hz 55Hz
POWER INPUT
GND GND+12V +12V
BLUE
WHITE
BADGE
LOGO
EXTENDED BASS CONTROL
WIDE NRW20Hz 80Hz
0° 180°
BALANCED
INPUT
BRX 12000 D
L
R
BRX 12000 D
SPEAKER OUTPUT
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics BRX12000D wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info