169035
15
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
15
Functions & Controls
TXi 3000
HIGH-/LOW PASS
High Pass
This controller adjust the frequency of the loudspeakers onward (X-OVER switch position HP). The cut-off frequency is continuously adjustable
from 10Hz to 1200Hz. This controller adjust also the Subsonic-Frequency in the LOW PASS-Mode (X-OVER switch position HP).
Low Pass
This controller adjust the frequency of the loudspeakers upward (X-OVER switch position LP/BP). The cut-off frequency is continuously
adjustable from 30Hz to 150Hz. Together with the HIGH PASS-Filter, this controller is also working as Bandpass-Filter (BPF). The cutting-off
of the lower frequencies ensures a tight kickbass-signal. If this function is not desired, bring the HIGH PASS-Controller to the 10 Hz position.
Bass Boost
Variable Bass Boost from 0 up to +12dB at 45 Hz.
Input - RCA Inputs
Full range line input to connect with
the head unit RCA Outputs.
Line Out - RCA Outputs
RCA Outputs to send the line signal
to additional amplifiers.
Level Input
Adjust the input sensitivity
from 6 Volts to 0,2 Volts.
Remote
Terminal for the provided cable remote
controller, which allows to control the bass
level e.g. out of the driver's seat.
Power - LED (also located
on the remote controller)
If green LED lights up, the
amplifier is turned on.
Protect - LED (also located on the remote controller)
If the red LED lights up, the following matters occurs:
a) Overheating
b) Speaker wires shorted
c) Overload (Impedance, weak power supply)
d) Amplifier is damaged
The built-in electronic diagnostic protection saves the
amplifier and speakers from serious damages.
If the red LED lights up due to overheating, let the
amplifier cool down a while, then turn it on again. If the red
LED still lights up, observe therefor the section “TROUBLE
SHOOTING”
X-Over
The switch determinates the operation mode of the amplifier.
Position LP/BP:
The Lowpass-/Bandpass-Mode is suited for subwoofer operations. The
signal will be limited upward and only the bass frequencies will be
amplified. The cut-off frequency is adjustable by the LOW PASS-
controller.
Position HP:
The Highpass-Mode is suited for loudspeaker operations. The signal is
limited downwards and only the mids and highs will be amplified.
The cut-off frequency is adjustable by the HIGH PASS-controller.
Position FULL:
The Fullrange-Mode is suited for very huge loudspeaker systems or huge
backshelf systems. Thereby the whole freqencies will be amplified.
6
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics txi3000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info