169036
18
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
18
718
Functions & Controls
TXi 3400
High Pass CH1/2 & CH3/4
This controller adjust the frequency of the
loudspeakers onward (X-OVER switch position HP).
The cut-off frequency is continuously adjustable
from 10Hz to 1200Hz.
Bass Boost CH3/4
Variable Bass Boost from 0 up to
+12dB at 45 Hz.
Line Out - RCA Outputs
RCA Outputs to send a 4CH mono
mix to an additional mono amp.
Input - RCA Inputs
Full range line input to connect with
the head unit RCA Outputs.
Level Input CH1/2 & CH3/4
Adjust the input sensitivity
from 6 Volts to 0,2 Volts.
Remote
Terminal for the provided cable remote
controller, which allows to control the bass
Power - LED (also located
on the remote controller)
If green LED lights up, the
amplifier is turned on.
Protect - LED (also located on the remote controller)
If the red LED lights up, the following matters occurs:
a) Overheating
b) Speaker wires shorted
c) Overload (Impedance, weak power supply)
d) Amplifier is damaged
The built-in electronic diagnostic protection saves the amplifier and
speakers from serious damages. If the red LED lights up due to
overheating, let the amplifier cool down a while, then turn it on again. If
the red LED still lights up, observe therefor the section “TROUBLE
SHOOTING”
Input Mode
If only CH1 and CH2 on the LINE INPUT are connected, set the switch
to position 2CH. If all channels on the LINE INPUT are connected, set
the switch to position 4CH.
Low Pass CH 3/4
This controller adjust the frequency of the
loudspeakers upward (X-OVER switch position LP).
The cut-off frequency is continuously adjustable from
30Hz to 150Hz.
X-Over CH3/4
Position LP/BP:
The Lowpass-/Bandpass-Mode is suited for
subwoofer operations. The signal will be limited
upward and only the bass frequencies will be
amplified. The cut-off frequency is adjustable by the
LOW PASS-controller.
Position HP:
The Highpass-Mode is suited for loudspeaker
operations. The signal is limited downwards and
only the mids and highs will be amplified.
The cut-off frequency is adjustable by the HIGH
PASS-controller.
Position FULL:
The Fullrange-Mode is suited for very huge
loudspeaker systems or huge backshelf systems.
Thereby the whole freqencies will be amplified.
X-Over CH1/2
Position DUPE:
In the DUPE-Mode all settings of CH 3/4 will be assigned to CH1/2.
Position HP:
The Highpass-Mode is suited for loudspeaker operations. The signal is limited
downwards and only the mids and highs will be amplified.
The cut-off frequency is adjustable by the HIGH PASS-controller.
Position FULL:
The Fullrange-Mode is suited for very huge loudspeaker systems or huge backshelf
systems. Thereby the whole freqencies will be amplified.
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics txi3400 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info