Bedienungsanleitung Hifonics Zeus ZRX (Seite 4 von 14) (Englisch)

505733

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

AMPLIFIER FEATURE DESCRIPTIONS

ZEUS ZRX AMPLIFIERS:

ZRX1200.1D / ZRX1800.1D / ZRX2400.1D / ZRX3200.1D 1-CHANNEL AMPLIFIERS

The 4 channel amps have the same features as the 2 channel models accept that there are 2 sets of

controls.

1 set for channels 1 & 2 and 1 set for channels 3 & 4.

In addition, the 4 channel models have a Mode switch. Switch to 2 channel if you only have 1 set of

RCA’s in CH 1/2 and the unit will automatically supply signal to channels 3/4. Select 3 channel if you

are running stereo on ch 1&2 and mono on ch 3&4. Select 4 channel if you are providing RCA’s to

channels 1/2 and 3/4.

The X-OVER slide switch selects the internal crossover functions:

-The input signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER setting

simplifying daisy chaining of amplifiers.

-HPF: Selects the built in HIGH PASS filter, variable from 60 Hz to 13kHz.

-FULL: Bypasses all crossovers for full frequency range operation.

-LPF: Selects the built in LOW PASS , variable from 30 Hz to 250Hz.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 6V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

BASS EQ: Fixed 45Hz bass boost variable from 0dB to 12dB.

Note that the LOW PASS signal is MONO.

-In the LPF position, the HIGH PASS filter acts as a

subsonic filter.

-When the LPF mode is selected, a 0 to +12dB, at 45Hz,

BASS EQ is also switched in.

ZRX600.4 / ZRX1000.4 / ZRX2000.4 4-CHANNEL AMPLIFIERS

The X-OVER slide switch selects the internal crossover functions:

-The input signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER setting

simplifying daisy chaining of amplifiers.

-HPF: Selects the built in HIGH PASS filter, variable from 60Hz to 13kHz.

-FULL: Bypasses all crossovers for full frequency range operation.

-LPF: Selects the built in LOW PASS , variable from 30Hz to 250Hz.

BASS EQ: Fixed 45Hz bass boost variable from 0dB to 12dB.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 6V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

Note that the LOW PASS signal is MONO.

-In the LPF position, the HIGH PASS filter acts as a

subsonic filter.

-When the LPF mode is selected, a 0 to +12dB, at 45Hz,

BASS EQ is also switched in.

ZRX500.2 / ZRX1200.2 2-CHANNEL AMPLIFIERS

POWER

LEVEL BASS EQ REMOTE SUBSONIC LOW PASS

PROTECT

OUTPUT

INPUT

6V 0.2V 0dB 10dB 15HZ 35HZ 30HZ 250HZ

CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU

Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation except

WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE

the mono amps which are capable of 4, 2 and 1-Ohm loads.

WARRANTY PRINTED IN THE BACK OF THE MANUAL. 2 & 4 Channel amps are capable of 4

The input sensitivities for rated output powers are variable from 0.2V to 6V.

and 2-Ohms wired stereo and 4-Ohms wired mono bridged. The mono amps are capable of 4, 2

All crossovers are fully variable in their respective ranges.

and 1-Ohm.

Crossover filters are 12dB/Octave.

A POWER LED indicates the powered up and turned on condition.

All Hifonics amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit,

and amplifier DC faults indicated by the red “PROTECT” LED.

POWER

LEVEL BASS EQ X-OVER HPF LPF MODE

PROTECT

OUTPUT

INPUT

6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ

FULL

MONO

HPF

STEREO

LPF

POWER

LEVEL BASS EQ X-OVER HPF LPF

CH 3 / 4

CH 1 / 2

LEVEL BASS EQ X-OVER HPF LPF MODE

PROTECT

CH 1 / 2

CH 3 / 4

LINE OUT

6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ

FULL

2 3 4

HPF

LPF

-The LINE INPUT signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER

setting simplifying daisy chaining of amplifiers.

-SUBSONIC: Allows you to adjust the crossover filter from 15Hz to 35Hz.

-LOW PASS: Allows you to adjust the LOW PASS crossover filter from 30Hz to 250Hz.

LEVEL: Adjusts the input sensitivity from 0.2 volts to 6 volts.

BASS EQ: The Bass EQ is adjustable from 0db to 10dB.

REMOTE: This is the input jack for the remote Level control.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 6V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hifonics Zeus ZRX Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info