167658
14
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
e13
021584
FUSE
GND REM BATT+ 12V
POWER INPUT
SPEAKER OUTPUT
+ CH3 + CH4
+ MONO BRIDGED
+ CH1 + CH2
14
Installation
Battery
12 V
In-Line
Fuse
Ground-
Connection
Ground-Connection
to vehicle's chassis
Remote Wire
(REM)
Installation Notes
The amplifier is generally mounted in the rear trunk area but can be mounted in any convenient area such as beneath a seat.
Please be sure to locate this unit where you have reasonable air circulation and protection from moisture. When considering the
mounting location you should minimize the length of the power and speaker leads. Minimizing both leads will yield a more reliable
installation. It is also important to ensure that the heat sink fins are not against a panel or a surface, preventing air circulation. Do
not install the amplifier on a subwoofer box or on vibrating parts of the vehicle, since the vibrations can cause damage to the
amplifiers electrical components.
Installation of the amplifier
Before starting with the installlation, mount the provided mounting brackets on the
amplifier. Mark the location for the mounting screw holes by using the amplifier as a
template. Drill holes at the marked locations as and firmly fasten the amplifier in place
with the mounting screws supplied in the accessory kit. Before drilling or cutting
any holes, investigate the layout of your automobile thoroughly. Take care when
working near the gas lines or hydraulic lines and electrical wiring.
Electrical Connection
Ground (GND)
This wire is the electrical ground and must be fastened securely to the vehicle chassis. The best method is to use a threading
sheet metal screw since the threads cut into bare metal. Ensure that all paint or other insulationis removed from around the hole
area, and using self tapping screw, securely affix the bare wire ends to the vehicle chassis. Use as short a piece of cable as
possible - use the same gauge as was used for the +12V cable. Make sure that the connection is safe and stable.
Remote (REM)
Connect the remote wire of your headunit with the remote turn-on of the power amplifier.
Battery Connection (+12V Power)
This wire is usually connected directly to the positive battery terminal. Ensure that the + power supply wire is fused via an in-line
fuse near by the battery. Please use a sufficient gauge (min. 25 sqmm) with spade lug with insulating sleeve.
Fuses
The integrated amplifier fuses protect the units from short circuit and overload. The fuse rating is for 4 Ohm loads (impedance) of
the speakers, for 2 Ohm loads the fuses may have to get increased by up to 50% in case of higher power consumption.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics zxi 9000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info