Bedienungsanleitung Hikoki CR10DL (Seite 6 von 172) (Alle Sprachen)

816371

Zoom out

Zoom in

Vorherige Seite

1/172

Nächste Seite

English

Table 1

Indications of the pilot lamp

Symbol mark

Pilot lamp

(red)

Before

charging Blinks Lights for 0.5 seconds. Does not light

for 0.5 seconds. (oﬀ for 0.5 seconds)

While

charging Lights Lights continuously

Charging

complete Blinks Lights for 0.5 seconds. Does not light

for 0.5 seconds. (oﬀ for 0.5 seconds)

Overheat

standby Blinks Lights for 1 second. Does not light

for 0.5 seconds. (oﬀ for 0.5 seconds)

Battery overheated.

Unable to charge.

(Charging will commence

when battery cools)

Charging

impossible Flickers Lights for 0.1 seconds. Does not light for

0.1 seconds. (oﬀ for 0.1 seconds)

Malfunction in the battery

or the charger

● Regarding the temperatures and charging time of the

battery.

The temperatures and charging time will become as

shown in Table 2.

Table 2

Charger

Battery UC10SL2

Charging voltage V 10.8

Weight kg 0.35

Type of battery Li-ion

Temperatures at which the

battery can be recharged 0oC – 50oC

Charging time for battery

capacity, approx. (At 20oC)

1.3 Ah

1.5 Ah

3.0 Ah

min.

25 (3 cells)

30 (3 cells)

60 (6 cells)

NOTE

The recharging time may vary according to the ambient

temperature and power source voltage.

4. Disconnect the charger’s power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

CAUTION

○ If the battery is charged while it is heated because it has

been left for a long time in a location subject to direct

sunlight or because the battery has just been used, the

pilot lamp of the charger lights for 1 second, does not

light for 0.5 seconds (oﬀ for 0.5 seconds). In such a case,

ﬁ rst let the battery cool, then start charging.

○ When the pilot lamp ﬂ ickers (at 0.2-second intervals),

check for and take out any foreign objects in the charger’s

battery connector. If there are no foreign objects, it is

probable that the battery or charger is malfunctioning.

Take it to your authorized Service Center.

○

Since the built-in micro computer takes about 3 seconds to

conﬁ rm that the battery being charged with charger is taken

out, wait for a minimum of 3 seconds before reinserting

it to continue charging. If the battery is reinserted within

seconds, the battery may not be properly charged.

MOUNTING AND OPERATION

Action Figure Page

Removing and inserting the

battery 1161

Charging 2 161

Mounting the blade 3 161

Removing a broken blade 4 161

Maintenance and inspection of

saw blade mount 5162

Base setting 6 162

Switch Operation 7 162

Select a saw blade of the

appropriate length 8162

Securing the materials to be cut 9 163

Plunge cutting 10 163

How to use the LED light 11 163

Battery level warning lamp

(Indicates that the battery level is

low and requires recharging.) 12 163

Selecting accessories ―164

0000BookCR10DL.indb60000BookCR10DL.indb6 2022/02/0215:26:232022/02/0215:26:23

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hikoki CR10DL Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info