Bedienungsanleitung Hikoki CR18DGL (Seite 6 von 188) (Alle Sprachen)

816425

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

English

Table 1

Indications of the pilot lamp

Pilot lamp

(red)

Before

charging Blinks Lights for 0.5 seconds. Does not light for 0.5

seconds. (oﬀ for 0.5 seconds)

While charging Lights Lights continuously

Charging

complete Blinks Lights for 0.5 seconds. Does not light for 0.5

seconds. (oﬀ for 0.5 seconds)

Overheat

standby Blinks Lights for 1 second. Does not light for 0.5

seconds. (oﬀ for 0.5 seconds)

Battery overheated.

Unable to charge.

(Charging will

commence when

battery cools)

Charging

impossible Flickers

Lights for 0.1 seconds. Does not light for 0.1

seconds. (oﬀ for 0.1 seconds) Malfunction in the

battery or the charger

○

Since the built-in micro computer takes about 3 seconds to

conﬁ rm that the battery being charged with charger is taken

out, wait for a minimum of 3 seconds before reinserting it

to continue charging. If the battery is reinserted within 3

seconds, the battery may not be properly charged.

○ If the pilot lamp does not blink in red (every second)

even though the charger cord is connected to the power,

it indicates that the protection circuit of the charger may

be activated.

Remove the cord or plug from the power and then

connect it again after 30 seconds or so. If this does

not cause the pilot lamp to blink in red (every second),

please take the charger to the HiKOKI Authorized

Service Center.

MOUNTING AND OPERATION

Action Figure Page

Mounting the blade 2 180

When the blade is broken 3 180

Select a saw blade of the

appropriate length 4 180

Fasten a workpiece ﬁ rmly 5 180

Removing and inserting the

battery 6181

Charging 7 181

Adjusting the base 8 181

Switch Operation 9 181

Plunge cutting (for wood) 10 181

Selecting accessories ―182

SELECTION OF BLADES

To ensure maximum operating eﬃ ciency and results, it is

very important to select the appropriate blade best suited to

the type and thickness of the material to be cut.

The blade number is engraved in the vicinity of the mounting

portion of each blade. Select appropriate blades by referring

to Table 3-5.

However, do not use No. 2 – 9 with the unit.

● Regarding the temperatures and charging time of the

battery.

The temperatures and charging time will become as

shown in Table 2.

Table 2

Charger

Battery UC18YKSL

Charging voltage V 14.4 – 18

Weight kg 0.35

Temperatures at which the battery

can be recharged 0oC – 50oC

Charging time (At 20oC) BSL1815 Approx. 40 min.

Number of battery cells 5

NOTE

The recharging time may vary according to the ambient

temperature and power source voltage.

CAUTION

When the battery charger has been continuously used,

the battery charger will be heated, thus constituting

the cause of the failures. Once the charging has been

completed, give 15 minutes rest until the next charging.

4. Disconnect the charger’s power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

CAUTION

○ If the battery is charged while it is heated because it has

been left for a long time in a location subject to direct

sunlight or because the battery has just been used, the

pilot lamp of the charger lights for 1 second, does not

light for 0.5 seconds (oﬀ for 0.5 seconds). In such a case,

ﬁ rst let the battery cool, then start charging.

○ When the pilot lamp ﬂ ickers (at 0.2-second intervals),

check for and take out any foreign objects in the charger’s

battery connector. If there are no foreign objects, it is

probable that the battery or charger is malfunctioning.

Take it to your authorized Service Center.

0000BookCR18DGL.indb60000BookCR18DGL.indb6 2018/05/1815:08:242018/05/1815:08:24

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hikoki CR18DGL Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info