Bedienungsanleitung Hikoki CV18DA (Seite 9 von 108) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

816253

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

English

Accessory case

Prohibited action

Warning

*1 Depending on attached battery. The heaviest weight is

measured with BSL36B18 (sold separately).

Battery

Lights ;

The battery remaining power is over 75%.

Lights ;

The battery remaining power is 50%–75%.

Lights ;

The battery remaining power is 25%–50%.

Lights ;

The battery remaining power is less than 25%.

Blinks ;

The battery remaining power is nearly empty.

Recharge the battery soonest possible.

Blinks ;

Output suspended due to high temperature.

Remove the battery from the tool and allow it to

fully cool down.

Blinks ;

Output suspended due to failure or malfunction.

The problem may be the battery so please

contact your dealer.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains

the accessories listed on page99.

Standard accessories are subject to change without notice.

APPLICATIONS

○ Flush cutting and pocket cutting of various materials

○ Peeling of tiles, caulking, etc.

○ Polishing wood materials, etc.

SPECIFICATIONS

1. Power tool

The specifications of this machine are listed in the

Table on page 99.

NOTE

Due to HiKOKI’s continuing program of research and

development, the specifications herein are subject to

change without prior notice.

2. Battery

Model Voltage Battery capacity

BSL1820M 18 V 2.0 Ah

CHARGING

Before using the power tool, charge the battery as follows.

1. Connect the charger’s power cord to the

receptacle.

When connecting the plug of the charger to a

receptacle, the pilot lamp will blink in red. (See Table1)

2. Insert the battery into the charger.

Firmly insert the battery into the charger as shown in

Fig.4 (on page 2).

3. Charging

When inserting a battery in the charger, charging will

commence and the pilot lamp will light continuously in

red.

When the battery becomes fully recharged, the pilot

lamp will blink in red. (See Table1)

(1) Pilot lamp indication

The indications of the pilot lamp will be as shown in

Table1, according to the condition of the charger or the

rechargeable battery.

Table 1: Indications of the pilot lamp

ON/OFF at 0.5sec. intervals Before charging *1

Charging complete

Lights continuously While charging

Lights for 1sec. at intervals of

0.5sec. Overheat standby *2

ON/OFF at 0.1sec. intervals Charging impossible

NOTE

*1 If the red lamp continues to blink even after the charger

has been attached, check to confirm that the battery

has been fully inserted.

*2 Battery overheated. Unable to charge.

Although charging will start once the battery has cooled

down even when left in situ, the best practice is to

remove the battery and allow it to cool down in a

shaded, well-ventilated location before charging.

*3 Malfunction in the battery or the charger

– Fully insert the battery.

– Check to confirm that no foreign matter is stuck to

the battery mount or terminals. If there are no

foreign objects, it is probable that the battery or

charger is malfunctioning. Take it to your authorized

Service Center.

○ If the pilot lamp does not blink in red even though the

charger cord is connected to the power, it indicates that

the protection circuit of the charger may be activated.

Remove the cord or plug from the power and then

connect it again after 5minutes or so. If this does not

cause the pilot lamp to blink in red, please take the

charger to the HiKOKI Authorized Service Center.

○ When the battery charger has been continuously used,

the battery charger will be heated, thus constituting the

cause of the failures. Once the charging has been

completed, give 15minutes rest until the next charging.

(2) Regarding the temperatures and charging time of the

battery. (See Table2)

2023/06/08 13:41:02Stylesheet: EU Version: 2023.4.24

CV18DA_C99749781_306_WE_NE_Gre

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hikoki CV18DA Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info