816294
4
Zoom out
Zoom in
Vorherige Seite
1/164
Nächste Seite
4
English
WARNING - If any foam or
water egresses, switch off
immediately. Empty the container
and, if need be, the pleated filter.
Never sit or stand on the device.
Always set up the connection lead
and hose so there is no danger of
tripping.
Do not pull the connection lead
over any sharp edges and do not
kink or pinch it.
If the connection lead of the device
is damaged, it must be replaced by
a special connection lead. See the
chapter on Repairs.
Always connect to a socket with
protective contact.
Do not use any damaged exten-
sion leads.
Never insert or remove the mains
plug with wet hands.
Only pull on the mains plug, not on
the lead.
WARNING - The plug socket on
the device must be used only for
the purposes defined in the oper-
ating Instructions.
Do not leave the device unat-
tended. If there is a long work inter-
ruption, disconnect the mains plug.
The dust extractor must not be
used or stored outside in wet
conditions.
IMPORTANT - This device must
only be stored indoors.
Acids, acetone and solvents can
corrode the device components.
Prior to any servicing work,
clean the device. Switch off the
device after each use and pull out
the mains plug.
Steam cleaners and high-pressure
cleaners must not be used to clean
the dust extractor.
The inside of the cover must
always be kept dry.
Mould contamination can result if
the device is not cleaned for an
extended period, especially if used
in areas where foodstuffs are
processed: Always clean and
disinfect the dust extractor immedi-
ately after use.
Never open the device outdoors
during rain or storms.
Do not use the device outdoors in
cold weather.
The device must not be operated in
areas with an explosion hazard.
Ensure that the dust extractor is
steady.
If the extracted air is discharged
into the room, ensure there is an
adequate air change rate (L) in the
room. Observe the regulations that
apply in your country.
Keep the tool socket dry and do not
expose to moisture.
Do not plug extension cords
between the dust extractor and the
power tool.
When using the tool socket, use
the dust extractor in a dry environ-
ment.
RP250YBL_C99749871_305.book 4 ページ 2023年4月6日 木曜日 午後12時6分
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hikoki RP250YBL wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info