Bedienungsanleitung Hikoki UC 18YML2 (Seite 9 von 56) (Alle Sprachen)

742236

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English

(2) Regarding the temperature of the rechargeable

battery.

The temperatures for rechargeable batteries are as

shown in the table below, and batteries that have

become hot should be cooled for a while before being

recharged.

Table 2

Temperatures at which the battery can be recharged

0°C - 50°C

(3) Regarding recharging time

Table 3 shows the recharging time required according

to the type of battery.

Table 3 Recharging time (approx. min.) at 20°C

(AC power supply/DC 12V (in-car) power supply)

Battery capacity (Ah)

Battery

Voltage

(V)

Li-ion BATTERY

1.5 Ah 3.0 Ah

14.4 V

BSL1415

BSL1415X

(4 cells)

22/60

min.

BSL1430

(8 cells)

45/120

min.

18 V

BSL1815X

(5 cells)

22/60

min.

BSL1830

(10 cells)

45/120

min.

NOTE

The recharging time may vary according to the

ambient temperature.

Especially, using a DC 12V in-car power source may

require longer recharging time at high temperatures.

E.g., approx. 170-180 min (3.0 Ah) at 40°C

4. Disconnect the charger’s power cord from the

receptacle or cigarette lighter socket

5. Hold the charger ﬁ rmly and pull out the battery

NOTE

Be sure to pull out the battery from the charger after

use, and then keep it.

Regarding electric discharge in case of new

batteries, etc.

As the internal chemical substance of new batteries

and batteries that have not been used for an extended

period is not activated, the electric discharge might be

low when using them the ﬁ rst and second time. This is

a temporary phenomenon, and normal time required

for recharging will be restored by recharging the

batteries 2–3 times.

How to make the batteries perform longer.

(1) Recharge the batteries before they become

completely exhausted.

When you feel that the power of the tool becomes

weaker, stop using the tool and recharge its battery.

If you continue to use the tool and exhaust the electric

current, the battery may be damaged and its life will

become shorter.

(2) Avoid recharging at high temperatures.

A rechargeable battery will be hot immediately after

use. If such a battery is recharged immediately after

use, its internal chemical substance will deteriorate,

and the battery life will be shortened. Leave the battery

and recharge it after it has cooled for a while.

CAUTION

 If the battery is charged while it is heated because

it has been left for a long time in a location subject

to direct sunlight or because the battery has just

been used, the pilot lamp of the charger lights up

green. In such a case, ﬁ rst let the battery cool, then

start charging.

 When the pilot lamp ﬂ ickers in red (at 0.2-seconds

intervals), check for and take out any foreign objects

in the charger’s battery connector. If there are no

foreign objects, it is probable that the battery or

charger is malfunctioning. Take it to your authorized

Service Center.

 Since the built-in micro computer takes about 3

seconds to conﬁ rm that the battery being charged

with UC18YML2 is taken out, wait for a minimum

of 3 seconds before reinserting it to continue charging.

If the battery is reinserted within 3 seconds, the battery

may not be properly charged.

 Check the voltage of the in-car power source when

the pilot lamp ﬂ ickers in green (every 0.2 seconds)

continuously.

If the voltage is 12V or lower, it indicates that the car

battery has weakened and cannot be charged.

 If the pilot lamp does not blink in red (every second)

even though the charger cord or cigarette lighter

connecting plug is connected to the power, it indicates

that the protection circuit of the charger may be

activated.

Remove the cord or plug from the power and then

connect it again after 30 seconds or so.If this does

not cause the pilot lamp to blink in red (every second),

please take the charger to the HiKOKI Authorized

Service Center.

MAINTENANCE AND INSPECTION

1. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that

they are properly tightened. Should any of the screws

be loose, retighten them immediately. Failure to do so

could result in serious hazard.

2. Cleaning of the charger

When the charger is stained, wipe with a soft dry cloth

or a cloth moistened with soapy water. Do not use

chloric solvents, gasoline or paint thinner, for they melt

plastics.

3. Store idle charger

When not in use, the charger should be stored in dry,

high or locked-up place — out of reach of children.

4. Fuse replacement of cigarette lighter connecting

plug

CAUTION

For continued protection against risk of ﬁ re, replace

only with same type and ratings of fuse in cigarette

lighter connecting plug.

250V, 6A, DC

CAUTION

In the operation and maintenance of power tools, the

safety regulations and standards prescribed in each

country must be observed.

NOTE

Due to HiKOKI’s continuing program of research and

development, the speciﬁ cations herein are subject to

change without prior notice.

000Book_UC18YML2_WE+NE.indb 9000Book_UC18YML2_WE+NE.indb 9 2019/07/25 22:43:282019/07/25 22:43:28

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hikoki UC 18YML2 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info