Bedienungsanleitung Himo ZB20 (Seite 29 von 36) (Englisch)

803206

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Testing method

Durability test

For the frame

Requirement

When testing by the method described in the "Test Method", the mark should be kept clear and

easy to read, the label should not be easy to remove, and there should be no signs of curling.

Wipe by hand with a cloth soaked in water for 15 seconds, and then wipe with a cloth soaked in

petroleum spirit for 15 seconds.

On easily visible parts, such as the position near the pedal crank, seat post or handlebar, clearly and persistently

mark a complete frame number;

Obviously and persistently mark the name of the manufacturer or manufacturer’s representative of the whole

electric-assisted bicycle and the number of this document, namely EN15194.; The durability test method is

specified in the "durability test". Where appropriate, if the electric assisted bicycle is equipped with a trailer

coupling device, the following values should be provided:

The total weight of the trailer;

The vertical load of the coupled system. Note: There are legal requirements for bicycle marking in some

countries. For components, there are currently no special requirements, but it is recommended that the following

critical safety components be clearly and permanently marked with traceable identities, such as the manufactur-

er’s name and part number:

Front fork

Handlebars and handle bars

Sea post

Brake lever, brake shoe and/or brake shoe bracket

Brake cable outer tube

Hydraulic brake hose

Disc brake calipers, brake discs, brake pads

Chain

Pedal and crank

Bottom bracket spindle

Rim

Warning 1 - Like all mechanical parts, electric assisted bicycles are subject to wear and high stress. Different

materials and components may respond differently to wear or stress fatigue. If the design life of the component

is exceeded, the component may suddenly fail, causing injury to the rider. Any form of cracks, scratches, or color

changes in high-stress areas indicates that the service life of the part has been reached and it should be

replaced.

Warning 2 - For composite parts, the user may not see the impact damage. The manufacturer should explain the

situation and consequences of the impact damage; composite parts should be returned to the manufacturer for

inspection or destruction and replacement.

The A-weighted sound pressure level at the rider’s ears should be less than 70 dB(A).

It is strictly prohibited to deliberately refit the bicycle or make unauthorized modifications to this bicycle.

The manufacturer/seller does not assume any responsibility for damage caused by modification by the user, and

it is recommended that the user seek professional help.

The child seat cannot be installed under the bicycle.

Never use a high-pressure cleaner to clean the bicycle.

For instructions on the minimum saddle height and size, please refer to the minimum insertion limit mark on the

seat post.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Himo ZB20 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info