Bedienungsanleitung Hisense 65A7300F (Seite 5 von 26) (Englisch)

769807

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Important Safety Instructions

Moving/Transportation

Before moving this TV, disconnect all

cables and move in the vertical position

only. Grasp the device on the upper and

lower edges of the frame.

- Do not press or put stress on the front

panel of the TV. It may take two or

more people to carry larger TVs.

If you have to briey lay down the TV,

place the unit with its entire front surface

lying at on soft material.

The LED screen is made of glass and can

break if is not handled properly. Always

wear rubber gloves to carry the unit. If

the LED screen is damaged, liquid crystal

might leak out. In case of skin contact,

immediately rinse thoroughly with water.

Power Supply

Incorrect voltages can damage the TV.

Only connect this unit to a power supply

with the correct voltage and frequency

noted on the type plate, using the

supplied power cable.

The power plug must be easily accessible

so that the device can be disconnected at

all time. The unit is live, even if in standby

mode, as long as the unit is connected to

a power outlet.

It is recommended that this unit is placed

on a dedicated circuit.

- Do not overload the power outlets by

connect too many appliances to the

same outlet. Overloaded wall outlets,

extension cords, etc. are dangerous

and can result in electric shock and

re.

After power off, don't turn it on again in

5 seconds. Frequent switching power

supply in a short period of time can cause

abnormal TV.

Power plug and power cable

- Do not touch the power plug with wet

hands.

- Do not place heavy objects on the

power cable. Route the cable so that it

is not kinked or laid over sharp edges,

walked on or exposed to chemicals. A

power cable with damaged insulation

can cause electric shock and re.

- Pull the power plug, NOT on the cable

when disconnecting. The cable can

become damaged and cause a short

circuit if pulled on.

- Do not place the power cable near a

high temperature object.

- Do not move the TV with the power

cable plugged into a socket.

- Do not use a damaged or loose power

cable, or a damaged socket outlet.

- Do not use any power cords other

than the one supplied with this unit.

Set-up

Check that the location is suitable to bear

the load of the TV. Place on a level, sturdy

and horizontal base. Ensure that the unit

does not hang over the edge of the base

when placed in or on furniture. If placed

on a cart, use caution when moving to

avoid the unit from tipping over.

- Place the unit in a normal upright

horizontal position. It must never

be operated vertically, lying at or

hanging overhead from the ceiling.

- Place the unit where it is not exposed to

direct sunlight or other sources of heat.

When mounting the TV on a wall, follow

the instructions supplied with the wall-

mount, make sure not to install the TV by

hanging the power and signal cables on

the back of the TV.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hisense 65A7300F Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hisense 65A7300F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info