637388
14
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
English - 11 -
Step 1 - Checking the TV and Accessories
Note: You should check the accessories after
purchasing. Make sure that each accessory is
included.
All models are supplied with the following items:
Instruction Book, Remote Control, 2 X AAA Batteries
and depending on which model you purchased, AV
connection Leads.
Step 2 - Installing the Batteries to the Remote
1. Lift the cover on the back of the remote gently.
2. Install two AAA/R3 batteries. Make sure the (+) and
(-) signs match (observe correct polarity).
3. Put the cover back on.
Note: Remove the batteries from remote control handset
when it is not going to be used for a long period of time.
Otherwise possible leakage from the batteries can
damage it. Operation range is approximately 7m/23ft.
Step 3 - Connect Power and Antenna/Cable
After unpacking, allow the TV set to reach the ambient room
temperature before you connect the set to the mains.
Power Cable Connection:
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz.
Plug the power cable to the mains socket outlet. Leave
at least 10mm space around the TV set.
Power off both the TV and the device before
making any connections.
Antenna Connection:
Connect the aerial/cable or satellite TV plug to the
Aerial, Cable or Satellite INPUT socket located at
the rear of the TV.
Satellite and Cable connection are dependent on the
model.
insert plug...
Make sure the power
plug is plugged securely
to the wall outlet.
satellite
aerial or cable
REAR OF THE TV
Step 4 - Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press Standby button. Then the standby LED lights
up.
To switch on the TV from standby mode either:
Press the Standby button, Programme +/- or a
numeric button on the remote control.
Control buttons on the TV
Press the Programme +/- button on the TV. The TV
will then switch on.
-or-
Press the middle of the control switch on the left side
of the TV. The TV will then switch on.
To Switch the TV Off(Optional)
Press the Standby button on the remote control or
press the Standby button on the TV or press and hold
the control switch on the TV until shut down, so the
TV will switch to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi 32HBC01 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Hitachi 32HBC01

Hitachi 32HBC01 Bedienungsanleitung - Deutsch - 25 seiten

Hitachi 32HBC01 Bedienungsanleitung - Holländisch - 24 seiten

Hitachi 32HBC01 Bedienungsanleitung - Französisch - 25 seiten

Hitachi 32HBC01 Bedienungsanleitung - Spanisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info