Bedienungsanleitung Hitachi C28W460N (Seite 19 von 24) (Englisch)

54241

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

- 18 -

Other Features

TV Status

Programme Number, Programme Name (or AV) and

Sound Indicator are displayed on the upper left of the

screen. They are displayed after programme change

during 3 seconds.

3

Programme Number

35

Programme Name (4 characters)

These OSDs are displayed when a new programme is

entered by digit button, by pressing   or   button,

or by TV button.

Double-digit (- -)

This OSD is displayed when the "Double-Digit" button

pressed in place of the programme number indicator.

After then, in order to enter a programme it must be

pressed to two digit consecutively. When it is late to

press any digit button this function will be ignored and

the display will be erased. In the same way it must not

be late to press any digit button after entering the first

digit. The limit of the delay time is 3 seconds.

Sound Indicator

This is a stereo option. The alternatives of the indicator

are Mono, Stereo, Dual-I and Dual-II. This indicator is

displayed under the programme number indicator on the

screen. "I-II" button is used to select Mono, Stereo,

Dual-I or Dual-II.

In Mono broadcast or in forced-mono (for stereo broad-

cast).

In Stereo broadcast.

If dual broadcast detected. Dual-I is selected in default

and also can be selected after Dual-II by Remote Con-

trol.

'8$/,

If Dual-II selected by Remote Control.

Picture Mode

The picture mode OSD is displayed below the sound

indicator, by TV Status OSDs. According to the WSS

data, inside of the OSD box 4:3 , 16:9, CINEMA,

SUBTITLE, ZOOM, PANORAMIC or AUTO is writ-

ten.

By pressing   (TXT_UPDATE) button (if Teletext is

not active) the picture mode can be switched into 4:3,

16:9, CINEMA, SUBTITLE, ZOOM, PANORAMIC

or AUTO Mode.

Mute Indicator

It is placed in the upper middle of the screen when en-

abled, and it stays there until it is disabled.

To cancel mute, there is two alternative; the first one is

pressing to " " button, thus volume is set to the pre-

ceding value, and the second one is increasing the vol-

ume level, thus it starts at the minimum level to increase.

By decreasing the volume level in mute state, mute will

not be ignored, only the volume level will decrease. If

mute canceled after decreasing the volume level, the

volume will valid with the decreased level.

Volume Bar

It is displayed in the lower middle of the screen. When

a volume command is received (pressing   or  

by Remote Control or Front panel) and no menu is ac-

tive, it stays on the screen for 3 seconds, after the last

volume command or until another command is received

in between.

AV Modes

By pressing the AV button you can switch your TV to

AV modes (except being in Teletext). Pressing this but-

ton will switch the TV in one of the optional AV modes:

EXT-1, RGB, EXT-2, F-AV or SVHS. EXT.1 and EXT.2

supports the RGB mode.

In order to quit the AV mode press the TV, digit but-

tons or   /  .

2853W-1244UK-ENG-ST7P-AK45-PLL-FS-CLED-50051552.p65 13.07.2004, 10:5418

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi C28W460N Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info