566230
8
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
8
English
WARNINGS AND SAFETY INSTRUCTIONS
Operator safety
Always wear a safety face shield or goggles.
Gloves should be used when sharpening chain.
Always wear safety protective equipment such as jacket,
trousers, gloves, helmet, boots with steel toe-caps and non-slip
soles, and eye, ear and leg protection equipment whenever you
use a chain saw. For
working in trees the safety boots must be
suitable for climbing techniques. Do not wear loose clothing,
jewelry, short pants, sandals or go barefoot.
Secure hair so it is above shoulder length.
Do not operate this tool when you are tired, ill or under the
in uence of alcohol, drugs
or medication.
Never let a child or inexperienced person operate the machine.
Wear hearing protection. Pay attention to your surroundings.
Be aware of any bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting o engine.
Wear head protection.
Never start or run the engine
inside a closed room or building.
Breathing exhaust fumes can kill.
For respiratory protection, wear a protection mask while emitting
the chain oil mist and dust from sawdust.
Keep handles free of oil and fuel.
Keep hands away from cutting equipment.
Do not grab or hold the unit by
the cutting equipment.
When the unit turned o , make sure the cutting attachment has
stopped before the unit is set down.
When operation is prolonged, take a break from time to time
so that you may avoid possible Hand-Arm Vibration Syndrome
(HAVS) which is caused by vibration.
The operator must obey the local regulations of cutting area.
WARNING
Antivibration systems do not guarantee that you will not sustain
Hand-Arm Vibration Syndrome or carpal tunnel syndrome.
Therefore, continual end regular users should monitor closely
the condition of their hands andngers. If any of the above
symptoms appear, seek medical advice immediately.
Long or continuous exposure to high
noise levels may cause
permanent hearing impairment. Always wear approved hearing
protection when operating a unit/machine.
If you are using any medical electric/electronic devices such
as a pacemaker, consult your physician as well as the device
manufacturer prior to operating any power equipment.
Unit/machine safety
Inspect the entire unit/machine before
each use. Replace
damaged parts. Check for fuel leaks and make sure all fasteners
are in place and securely tightened.
Replace parts that are cracked, chipped or damaged in any way
before using the unit/machine.
Make sure the side case is properly attached.
Keep others away when making carburetor
adjustments.
Use only accessories as recommended for this unit/machine by
the manufacturer.
Never let the chain strike any obstacle. If the chain makes
contact, the machine should be stopped and checked carefully.
Make sure the automatic oiler is working. Keep the oil tanklled
with clean oil. Never let
chain run dry on the bar.
All chain saw service, other than the items listed in the
operator’s/ owner’s manual, should be performed by Hitachi
Authorized Service Centers. (For example, if improper tools are
used to remove theywheel or if an improper tool is used to hold
theywheel
in order to remove the clutch, structural damage
to theywheel could occur and could subsequently cause the
ywheel to burst.)
WARNING
Never modify the unit/machine in any way. Do not use your unit/
machine for any job except that for which it is intended.
Never use chain saw without any safety equipment or that has
faulty safety equipment. It could result in serious personal injury.
Using guide bar/chain other than
recommended by the
manufacturer which are not approved, could result in a high risk
of personal accidents or injury.
Fuel safety
Mix and pour fuel outdoors and where there are no sparks or
ames.
Use a container approved for fuel.
Do not smoke or allow smoking near fuel or
the unit/machine or
while using the unit/machine.
Wipe up all fuel spills before starting engine.
Move at least 3 m away from fueling site before starting engine.
Stop engine and let it cool for a few minutes before removing fuel
tank cap.
Empty the fuel tank before storing
the unit/machine. It is
recommended that the fuel be emptied after each use. If fuel is
left in the tank, store so fuel will not leak.
Store unit/machine and fuel in area where fuel vapors cannot
reach sparks or openames from water heaters, electric motors
or switches, furnaces, etc.
WARNING
Fuel is easy to ignite or get explosion or inhale fumes, so that pay
special attention when handling orlling fuel.
Cutting safety
Do not cut any material other than wood or wooden objects.
For respiratory protection, wear an aerosol protection mask
when cutting the wood after insecticide has
been applied.
Keep others including children, animals, bystanders and helpers
outside the hazard zone. Stop the engine immediately if you are
approached.
Hold the unit/machinermly with the right hand on the rear
handle and the left hand on the front handle.
Keeprm footing and balance. Do not
over-reach.
Keep all parts of your body away from the mu er and cutting
attachment when the engine is running.
Keep Bar/Chain below waist level.
Before felling a tree, the operator must be accustomed to the
sawing techniques of the chain saw.
Be sure to pre-plan a safe
exit from a failing tree.
While cutting, hold the unit/machinermly with both hands with
thumbrmly locked around front handle, and stand with feet well
balanced and your body balanced.
Stand to the side of the saw when cutting - never directly behind
it.
Always keep the spiked
bumper face to a tree, because the
chain may suddenly be drawn into a tree, if so equipped.
When completing a cut, be ready to hold up the units as it breaks
into clear, so it will not follow through and cut your legs, feet or
body, or contact an
obstruction.
Be alert against kickback (when saw kicks up and back at
operator). Never cut with the nose of the bar.
When relocating to a new work area, be sure to shut o the
machine and ensure that all cutting attachments are stopped.
Never place the machine on the
ground when running.
Always ensure that the engine is shut o and any cutting
attachments have completely stopped before clearing debris or
removing grass from the cutting attachment.
Always carry arst-aid kit when operating any power equipment.
Never start or run the engine inside a closed room
or building
and/or near the in ammable liquid. Breathing exhaust fumes
can kill.
Maintenance safety
Maintain the unit/machine according to recommended
procedures.
Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
Keep others away when making carburetor adjustments.
Use only genuine HITACHI replacement parts as recommended
by
the manufacturer.
CAUTION
Do not disassemble the recoil starter. Yo u may get a possibility
of personal injury with recoil spring.
WARNING
Improper maintenance could result in serious engine damage or
in serious personal injury.
000Book_CS51EAP_WE.indb 8000Book_CS51EAP_WE.indb 8 2012/03/16 16:01:202012/03/16 16:01:20
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi CS51EAP wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info