Bedienungsanleitung Hitachi DV18DVF (Seite 10 von 76) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

566559

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

English

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the

accessories listed in the table below.

DV14DVF

DV18DVF

1 Plus driver bit (No. 2 × 65L) ....................1

2 Charger (UC18YG or UC18YK) ..............1

3 Battery ....................................................2

Battery ....................................................3

4 Plastic case ............................................ 1

Standard accessories are subject to change without notice.

OPTIONAL ACCESSORIES (sold separately)

1. Battery (EB1414S, BCC1412)

(For DV14DVF)

2. Battery (EB1814SL, BCC1812)

(For DV18DVF)

Optional accessories are subject to change without notice.

APPLICATIONS

○ Drilling of brick and concrete block, etc.

○ Driving and removing of machine screws, wood screws,

tapping screws, etc.

○ Drilling of various metals.

○ Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal

Hold the handle tightly and push the battery latch (2 pcs.)

to remove the battery (see Figs. 1 and 2).

CAUTION

Never short-circuit the battery.

2. Battery installation

Insert the battery while observing its polarities (see

Fig. 2).

CHARGING

Before using the power tool, charge the battery as follows.

1. Connect the charger power cord to the receptacle

Connecting the power cord will turn on the charger.

2. Insert the battery into the charger

Insert the battery ﬁ rmly while observing its direction,

until it contacts the bottom of the charger (See

Fig. 3). (The pilot lamp lights up.)

CAUTION

If the pilot lamp does not light up when the battery is

inserted, pull out the power cord from the receptacle

and check the battery mounting condition.

(1) Regarding the temperatures of the rechargeable battery

The temperatures for rechargeable batteries are as

shown

in Table 1.

Table 1 Recharging ranges of batteries

Rechargeable batteries

Temperatures at

which the battery

can be recharged

EB1414S, EB1814SL,

BCC1412, BCC1812

0°C – 45°C

(2) Regarding time

Depending on the combination of the charger and

batteries, the charging time will become as shown in

Table 2.

Table 2 Charging time (At 20°C)

Charger

Battery

UC18YG UC18YK

EB1414S, EB1814SL,

BCC1412, BCC1812

Approx.

30 min.

Approx.

50 min.

The pilot lamp goes oﬀ to indicate that the battery is fully

charged.

The battery charging time becomes longer when a

temperature is low or the voltage of the power source is

too low.

When the pilot lamp does not

go oﬀ even if more than 120

minutes have elapsed after starting of the charging, stop

the charging and contact your HITACHI AUTHORIZED

SERVICE CENTER.

CAUTION

If the battery is heated due to direct sunlight, etc.,

just after operation, the charger pilot lamp may not

light up. At that time, cool

the battery ﬁ rst, then start

charging.

3. Disconnect the charger’s power cord from the

receptacle

4. Hold the charger ﬁ rmly and pull out the battery

NOTE

After charging, pull out batteries from the charger ﬁ rst,

and then keep the batteries properly.

Regarding electric discharge in case of new batteries,

etc.

As the internal chemical substance of new batteries and

batteries that have not been used for an extended period

is not activated, the electric discharge might be low when

using them the ﬁ rst and second time. This is a temporary

phenomenon, and

normal time required for recharging

will be restored by recharging the batteries 2 – 3 times.

How to make the batteries perform longer.

(1) Recharge the batteries before they become completely

exhausted.

When you feel that the power of the tool becomes

weaker, stop using the tool and recharge its battery. If

you continue to use the tool and exhaust the electric

current, the battery may be

damaged and its life will

become shorter.

(2) Avoid recharging at high temperatures.

A rechargeable battery will be hot immediately after use.

If such a battery is recharged immediately after use, its

internal chemical substance will deteriorate, and the

battery life will be shortened. Leave the battery and

recharge it after

it has cooled for a while.

PRIOR TO OPERATION

1. Setting up and checking the work environment

Check if the work environment is suitable by following the

precautions.

000Book_DV14DVF_Tha.indb 10000Book_DV14DVF_Tha.indb 10 2010/04/06 17:39:082010/04/06 17:39:08

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi DV18DVF Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info