Bedienungsanleitung Hitachi DZ-MV270A (Seite 42 von 114) (Englisch)

604699

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

English

Recording Movie

Set the power switch to “ VIDEO”.

Once the DVD video camera/recorder starts to

recognize the disc, the CHARGE/ACCESS in-

dicator will light.

When recognition is finished, the CHARGE/

ACCESS indicator will go out.

Press the REC button.

The “ ” mark in the viewfinder or on the LCD

screen will change to the “ ” mark, and re-

cording will start.

During recording, the recording indicator on the

front of DVD video camera/recorder will light.

Pressing REC again during recording will set the

DVD video camera/recorder to the recording

pause status.

When recording is finished, set the power switch

to “POWER OFF” to turn the DVD video cam-

era/recorder off.

Note: When recording in a dark place, it is rec-

ommended that you use the optional video light

(model DZ-LD9). Refer to the instruction manual of

video light for details.

Note: Press down the LOCK switch above the

power switch to lock movie recording: The power

switch will lock and thereafter will not move to

“

PHOTO” by mistake.

Note: Sound is recorded from the stereo micro-

phone on the front of DVD video camera/recorder:

Take care that this microphone is not blocked.

Note: You can press the REC button immediately

after recording is finished, but no further recording

will be made while “DISC ACCESS” is being displayed.

Recording will restart after the message disappears.

Note: If a very bright subject is recorded, stripe-like

lights may appear above and below the subject.

Note: Take care that power is not interrupted

while the CHARGE/ACCESS indicator is blinking.

Note: The minimum recordable time of movie is

approximately 3 seconds.

Note: See page 64 for setting of Record LED (re-

cording indicator) On/Off.

Note: For various functions available during record-

ing, see “Setting Up Camera Functions” on page 54.

Note: Hitachi cannot be responsible for video

and audio that cannot be recorded or edited be-

cause of any defect.

Note: The power switch can be changed over

even during recording, but the operation will not

be changed.

●

Power save and discharge of battery

If, when “Power Save: On” is specified, the DVD video

camera/recorder is left in the recording pause status for

approximately 5 minutes, it will automatically turn off.

To restart recording, set the power switch to

“POWER OFF”, and then set it to “ VIDEO”.

To set or release power save, see “Setting or Re-

leasing Power Save” on page 63.

It is recommended that you specify “Power Save: On”,

since even during recording pause battery power is

consumed at the same level as during recording. Es-

pecially when power save has been released, turn the

DVD video camera/recorder off when not in use.

Using External Microphone

Connect external microphone (generally available) to the external microphone jack of this DVD video

camera/recorder. Clearer sound can be recorded. Turn on the switch on microphone and start recording.

For details on microphone, see “Major Specifications” on page 110.

To external

microphone jack

CHARGE/ACCESS

indicator

Power switch

LOCK switch

REC button

Insert a recordable DVD-RAM or DVD-R disc into this DVD video camera/recorder.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi DZ-MV270A Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info