604700
8
Zoom out
Zoom in
Vorherige Seite
1/141
Nächste Seite
8
Do not turn the DVD video camera/recorder off while the ACCESS indicator or
CARD ACCESS indicator is lit or blinking:
The ACCESS or CARD ACCESS indicator is lit or blinking
to show that data is being written to disc or card, or being
read from it. At this time, do not do any of the following,
so as not to damage the data:
Remove battery
Disconnect AC adapter/charger
Remove disc or card
Subject DVD video camera/recorder to severe
vibrations or impact
Violently open or close the LCD monitor
The ACCESS indicator will light for a while after recording
is finished. While it is lit, do not subject the DVD video
camera/recorder to any vibration or impact, and do not
disconnect the battery or AC adapter/charger.
If you turn the DVD video camera/recorder off while the
ACCESS or CARD ACCESS indicator is lit or blinking, turn
it on again with the disc or card loaded in it: Repair of the
disc or card will be executed automatically (see page 121).
Do not wipe the DVD video camera/recorder case with benzene or thinner:
The coating of case could peel off or the case surface could deteriorate.
When using a chemical cleaning cloth, follow the instructions.
Also read the instructions attached with optional accessories:
For optional accessories, observe the cautions and follow instruction manuals attached.
The battery provided has not been charged at time of purchase:
Charge it before using the DVD video camera/recorder (see page 38).
The battery will discharge as time passes. (The battery is produced so that it discharges on its own
in order to protect its characteristics.)
Disc cannot be inserted or removed unless a charged battery or AC adapter/
charger is connected to the DVD video camera/recorder.
Be sure to set the power switch to “OFF” when turning the DVD video camera/
recorder off:
Disconnecting the battery or AC adapter/charger while the DVD video camera/recorder is being
powered could cause a fault.
Do not use this DVD video camera/recorder with the cover of SD card insertion slot
left open.
CARD ACCESS indicator
ACCESS
indicator
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi DZ-MV5000E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info