Bedienungsanleitung Hitachi NR90GR2 (Seite 9 von 90) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

568888

Zoom out

Zoom in

Vorherige Seite

1/90

Nächste Seite

English

⅜ Keep the firing head down.

Strictly observe the above instructions, and always

make sure that no part of the body, hands or

legs is ever in front of the nail outlet.

12. Do not carelessly place your finger on the trigger.

Do not place your finger on the trigger except when

actually nailing. If you carry this tool or hand it to

someone while having your finger on the trigger,

you may inadvertently discharge a nail and thus

cause an accident.

13. Press the nail outlet firmly against the material to

be nailed.

When driving in nails, press the nail outlet firmly

against the material to be nailed. If the outlet is not

applied properly, the nails may rebound.

14. Keep hands and feet away from the firing head

when using.

It is very dangerous for a nail to hit

the hands or feet by mistake.

15. Do not touch around the exhaust outlet.

This tool produces hot exhaust gases

that may flammable materials. The

push lever and nose will become hot

and get heated up after prolonged or

rapid use.

Do not touch with bare hands.

16. Beware of the tool’s kickback.

Do not approach the top of the tool with your head

etc. during operation. This is dangerous because the

tool may recoil violently if the nail currently being

driven in comes into contact with a previous nail or

a knot in the wood.

17. Take care when nailing thin boards or the corners

of wood.

When nailing thin boards, the nails may pass right

through, as may also be the case when nailing the

corners of wood due to deviation of the nails. In such

cases, always make sure that there is no one (and

nobody’s hands or feet; etc.) behind the thin board

or next to the wood you are going to nail.

18. Simultaneous nailing on both sides of the same wall

is dangerous.

Under no circumstances should nailing be

performed on both sides of a wall at the same time.

This would be very dangerous since the nails might

pass through the wall and thus cause injuries.

19. Do not use the power tool on scaffoldings, ladders.

The power tool shall not be used for specific

application for example:

– when changing one driving location to another

involves the use of scaffoldings, stairs, ladders or

ladder alike constructions, e.g. roof laths,

– closing boxes or crates,

– fitting transportation safety systems e.g. on

vehicles and wagons

20. Disconnect the battery and fuel cell and take out

any nails left in the magazine after use.

Disconnect the battery and fuel cell from the tool

before doing tool maintenance, cleaning a jammed

fastener, leaving work area, moving tool to another

location, or after use. It is very dangerous for a nail

to be fired by mistake.

21. When removing a nail which has become stuck,

make sure to first of all disconnect the battery and

fuel cell.

When removing a nail which has become stuck in

the nail outlet, first of all make sure to disconnect

the battery and fuel cell inside the power tool.

Accidental firing of the nail could be very dangerous.

22.

The operating environment for this device is

between 0°C (32°F) and 40°C (104°F) so ensure use

within this temperature range. The device may fail

to operate below 0°C (32°F) or above 40°C (104°F) .

23. Always charge the battery at an ambient

temperature of 0–40°C.

A temperature of less than 0°C will result in over

charging which is dangerous. The battery cannot

be charged at a temperature greater than 40°C.

The most suitable temperature for charging is that

of 20–25°C.

24. Do not use the charger continuously.

When one charging is completed, leave the charger for

about 15 minutes before the next charging of battery.

25. Do not allow foreign matter to enter the hole for

connecting the rechargeable battery.

26. Never disassemble the rechargeable battery or

charger.

27. Never short-circuit the rechargeable battery.

Short-circuiting the battery will cause

a great electric current and overheat.

It results in burn or damage to the

battery.

28. Do not dispose of the battery in fire.

If the battery is burnt, it may explode.

29. Using an exhausted battery will damage the

charger.

30. Bring the battery to the shop from which it was

purchased as soon as the post-charging battery life

becomes too short for practical use.

Do not dispose of the exhausted battery.

31. Do not insert objects into the air ventilation slots

of the charger.

Inserting metal objects or flammable into the

charger air ventilation slots will result in an electrical

shock hazard or damage to the charger.

32. Do not inhale its contents.

In case of being inhaled ; the person

affected should be taken into the

open air and brought into a

comfortable position.

33. Expanding gases cause low temperatures.

Fluid gases might cause injuries when getting in

touch with skin or eyes.

– In case of contact with skin; wash the contact

surface carefully with warm water and soap and

apply a skin cream when dry.

– In case of contact with eyes; rinse the open eyes

under running water.

Contact a doctor if necessary.

34. Fuel cells.

Store in well–ventilated area.

Do not store above 50°C (120°F)

(e.g. direct sunlight or in a vehicle).

Do not expose to an open flame

and sparks.

Do not puncture or open the fuel cell.

Do not refill, reclaim or recycle the fuel cell.

Dispose of according to local regulations for aerosol

products.

MAX 50°C

(120°F)

01Eng_NR90GC2_WE_7L 4/14/08, 8:11 PM8

Hitachi NR90GR2 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info