Bedienungsanleitung Hitachi TCG24EBSPS (Seite 6 von 88) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

571071

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

English

(Original instructions)

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.

Symbols

WARNING

The following show symbols used for the machine. Be sure that you understand their meaning before use.

It is important that you read, fully

understand and observe the following

safety precautions and warnings. Careless

or improper use of the unit may cause

serious or fatal injury.

Ignition stop

Read, understand and follow all warnings

and instructions in this manual and on

the unit.

Fuel and oil mixture

Always wear eye, head and ear protectors

when using this unit.

Idle speed adjustment

Do not use metal/rigid blades when this

sign is shown on the unit.

Priming pump

Keep all children, bystanders and helpers

15 m away from the unit. If anyone

approaches you, stop the engine and

cutting attachment immediately.

Guaranteed Sound power level

Be careful of thrown objects.

Hot Surface – Contact with hot surface

can cause serious burns.

min

-1

Shows maximum shaft speed. Do not use

the cutting attachment whose max rpm is

below the shaft rpm.

The hedge trimmer attachment cannot

be used on models with this label.

Gloves should be worn when necessary,

e.g., when assembling cutting equipment.

Blade thrust may occur when the

spinning blade contacts a solid object

in the critical area. A dangerous

reaction may occur causing the entire

unit and operator to be thrust violently.

This reaction is called blade thrust. As

a result, the operator may lose control

of the unit which may cause serious or

fatal injury. Blade thrust is more likely

to occur in areas where it is diﬃ cult to

see the material to be cut.

Use anti-slip and sturdy footwear.

Choke - Run position (Open)

Choke - Start position (Closed)

Indicate handle location. Do not attach

handle above this point.

Before using your machine

• Read the manual carefully.

• Check that the cutting equipment is correctly assembled and adjusted.

• Start the unit and check the carburetor adjustment. See “MAINTENANCE”.

Contents

WHAT IS WHAT .................................................................................7

WARNINGS AND SAFETY INSTRUCTIONS ...................................8

SPECIFICATIONS .............................................................................9

ASSEMBLY PROCEDURES ............................................................10

OPERATING PROCEDURES ..........................................................12

MAI NT ENA NCE ............................................................................... 12

TROUB LESHOOTIN G .....................................................................15

000Book_TCG24EBSP_WE.indb 6000Book_TCG24EBSP_WE.indb 6 2014/03/26 14:05:112014/03/26 14:05:11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi TCG24EBSPS Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info