Bedienungsanleitung Hitachi UC24YJ (Seite 4 von 37) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

571396

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

English

GENERAL OPERATIONAL PRECAUTIONS

1. Keep work area clean. Cluttered areas and benches

invite accidents.

2. Avoid dangerous environment. Don’t expose power

tools and charger to rain. Don’t use power tools and

charger in damp or wet locations. And keep work

area well lit.

Never use power tools and charger near flammable

or explosive materials.

Do not use tool and charger in presence of flammable

liquids or gases.

3. The appliance is not intended for use by young

children or infirm persons without supervision. Young

children should be supervised to ensure that they do

not play with the appliance. All visitors should be

kept safe distance from work area.

4. Store idle tools and charger. When not in use, tools

and charger should be stored in dry, high or locked-

up place — out of reach or children. Store tools and

charger in a place in which the temperature is less

than 40°C.

5. Don’t abuse cord. Never carry charger by cord or

yank it to disconnect from receptacle. Keep cord from

heat, oil and sharp edges.

6. When the charger is not in use or when being

maintained and inspected, disconnect the power cord

of the charger from the receptacle.

7. To avoid danger, always use only the specified

charger.

8. Use only genuine HITACHI replacement parts.

9. Do not use power tools and charger for applications

other than those specified in the Handling Instructions.

10. To avoid personal injury, use only the accessories or

attachment recommended in these handling

instructions or in the HITACHI catalog.

11. If the supply cord is damaged, it must be replaced by

the manufacture or its service agent or a similarly

qualified person in order to avoid a hazard.

Let only the authorized service center do the repairing.

The Manufacture will not be responsible for any

damages or injuries caused by repair by the

unauthorized persons or by mishandling of the tool.

12. To ensure the designed operational integrity of power

tools and charger, do not remove installed covers or

screws.

13. Always use the charger at the voltage specified on

the nameplate.

14. Always charge the battery before use.

15. Never use a battery other than that specified. Do not

connect a usual dry cell, a rechargeable battery other

than that specified or a car battery to the power tool.

16. Do not use a transformer containing a booster.

17. Do not charge the battery from an engine electric

generator or DC power supply.

18. Always charge indoors. Because the charger and

battery heat slightly during charging, charge the

battery in a place not exposed to direct sunlight;

where the humidity is low and the ventilation is good.

19. Use the exploded assembly drawing on this handling

instructions only for authorized servicing.

PRECAUTIONS FOR CHARGER

1. Always charge the battery at a temperature of 0 –

40°C. A temperature of less than 0°C will result in

over charging which is dangerous. The battery cannot

be charged at a temperature higher than 40°C. The

most suitable temperature for charging is that of 20 –

25°C.

2. When one charging is completed, leave the charger

at least 5 minutes before the next charging of battery.

Do not charge more than two batteries consecutively.

3. Do not allow foreign matter to enter the hole for

connecting the rechargeable battery.

4. Never disassemble the rechargeable battery and

charger.

5. Never short-circuit the rechargeable battery. Short-

circuiting the battery will cause a great electric current

and overheat. It results in burn or damage to the

battery.

6. Do not dispose of the battery in fire.

If the battery is burnt, it may explode.

7. Using an exhausted battery will damage the charger.

8. Bring the battery to the shop from which it was

purchased as soon as the post-charging battery life

becomes too short for practical use. Do not dispose

of the exhausted battery.

9. Do not insert object into the air ventilation slots of

the charger.

Inserting metal objects or inflammables into the

charger air ventilation slots will result in electrical

shock hazard or damaged charger.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi UC24YJ Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info