Bedienungsanleitung Hitachi UC36YRSL (Seite 5 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

571399

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English

GENERAL OPERATIONAL PRECAUTIONS

1. Keep work area clean. Cluttered areas and benches

invite accidents.

2. Avoid dangerous environment. Don’t expose power

tools and charger to rain. Don’t use power tools

and charger in damp or wet locations. And keep

work area well lit.

Never use power tools and charger near flammable

or explosive materials.

Do not use tool and charger in presence of

flammable liquids or gases.

3. This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by

a person responsible for their safety.

Children should be supervised to ensure that they

do not play with the appliance.

4. Store idle tools and charger. When not in use, tools

and charger should be stored in dry, high or locked-

up place — out of reach or children. Store tools

and charger in a place in which the temperature

is less than 40°C.

5. Don’t abuse cord. Never carry charger by cord or

yank it to disconnect from receptacle. Keep cord

from heat, oil and sharp edges.

6. When the charger is not in use or when being

maintained and inspected, disconnect the power

cord of the charger from the receptacle.

7. To avoid danger, always use only the specified

charger.

8. Use only genuine HITACHI replacement parts.

9. Do not use power tools and charger for applications

other than those specified in the Handling

Instructions.

10. To avoid personal injury, use only the accessories

or attachment recommended in these handling

instructions or in the HITACHI catalog.

11. If the supply cord is damaged, it must be replaced

by the manufacture or its service agent or a similarly

qualified person in order to avoid a hazard.

Let only the authorized service center do the

repairing. The Manufacture will not be responsible

for any damages or injuries caused by repair by

the unauthorized persons or by mishandling of the

tool.

12. To ensure the designed operational integrity of

power tools and charger, do not remove installed

covers or screws.

13. Always use the charger at the voltage specified on

the nameplate.

14. Always charge the battery before use.

15. Never use a battery other than that specified. Do

not connect a usual dry cell, a rechargeable battery

other than that specified or a car battery to the

power tool.

16. Do not use a transformer containing a booster.

17. Do not charge the battery from an engine electric

generator or DC power supply.

18. Always charge indoors. Because the charger and

battery heat slightly during charging, charge the

battery in a place not exposed to direct sunlight;

where the humidity is low and the ventilation is

good.

19. Use the exploded assembly drawing on this handling

instructions only for authorized servicing.

PRECAUTIONS FOR CHARGER

1. Always charge the battery at an ambient temperature

of 0–40°C. A temperature of less than 0°C will result

in over charging which is dangerous. The battery

cannot be charged at a temperature greater than

40°C.

The most suitable temperature for charging is that

of 20–25°C.

2. Do not use the charger continuously.

When one charging is completed, leave the charger

for about 15 minutes before the next charging of

battery.

3. Do not allow foreign matter to enter the hole for

connecting the rechargeable battery.

4. Never disassemble the rechargeable battery or

charger.

5. Never short-circuit the rechargeable battery.

Short-circuiting the battery will cause a great electric

current and overheat. It results in burn or damage

to the battery.

6. Do not dispose of the battery in fire.

If the battery is burnt, it may explode.

7. Using an exhausted battery will damage the charger.

8. Bring the battery to the shop from which it was

purchased as soon as the post-charging battery life

becomes too short for practical use. Do not dispose

of the exhausted battery.

9. Do not insert objects into the air ventilation slots

of the charger.

Inserting metal objects or flammable into the charger

air ventilation slots will result in an electrical shock

hazard or damage to the charger.

SPECIFICATION

CHARGER

BSL1415 (4), BSL1415X (4), BSL1815 (5), BSL1815X (5) Approx. 30 minutes

BSL1420 (4), BSL1820 (5) Approx. 40 minutes

Charging time BSL1430 (8), BSL1830 (10), BSL2530 (14), BSL3620 (10) Approx. 60 minutes

BSL1440 (8), BSL1840 (10), BSL3626 (20) Approx. 80 minutes

BL36200 (80) Approx. 10 hours

Charging voltage 14.4 V – 36 V

Weight 0.7 kg

( ): cells

01Eng_UC36YRSL_WE_NE 1/9/13, 14:435

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi UC36YRSL Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info