Bedienungsanleitung Hitachi WH 12 DAF (Seite 8 von 74) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

78946

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

English

3. Hexagonal socket

4. Wood working drill: Code No. 959183

5. Drill chuck adapter set: Code No. 996195

Use the drills available on the local market.

Optional accessories are subject to change without notice.

APPLICATION

⅜ Driving and removing of small screws, small bolts,

etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal

Hold the handle tightly and push the battery latch to

remove the battery. (Figs. 1 and 2)

CAUTION

Never short-circuit the battery.

2. Battery installation

Insert the battery while observing its polarities (see

Fig. 2).

CHARGING

〈〈

〈

UC12SD

〉〉

〉

Before using the impact driver, charge the battery as

follows.

1. Insert the battery into the charger.

Insert the battery firmly while observing its direction,

until it contacts the bottom of the charger. (See Figs.

1 and 2)

CAUTION

The UC12SD model is the exclusively designed

charger. This cannot charge batteries except the

specified batteries. It is possible to insert the

batteries other than the specified into the charger

and it may light up the pilot lamps. However, you

are requested to exercise utmost caution not to

charge batteries other than specified ones because

these can not only be charged but also such

actions can result in the malfuntion of chargers.

2. Connect the charger power cord to the receptacle.

Connecting the power cord will turn on the charger

(the pilot lamp lights up).

CAUTION

If the pilot lamp does not light up, pull out the

power cord from the receptacle and check the

battery mounting condition.

About 1 hour is required to fully charge the battery at

a temperature of about 20°C. The pilot lamp goes off

to indicate that the battery is fully charged.

The battery charging time becomes longer when a

temperature is low or the voltage of the power source

is too low.

When the pilot lamp does not go off even if more than

two hours have elapsed after starting of the charging,

stop the charging and contact your HITACHI

AUTHORIZED SERVICE CENTER.

CAUTION

If the battery is heated due to direct sunlight, etc.,

just after operation, the charger pilot lamp may

not light up. At that time, cool the battery first,

then start charging.

3. Disconnect the charger power cord from the

receptacle.

4. Hold the charger firmly and pull out the battery.

NOTE

After charging, pull out batteries from the charger first,

and then keep the batteries properly.

Regarding electric discharge in case of new

batteries, etc.

As the internal chemical substance of new batteries

and batteries that have not been used for an extended

period is not activated, the electric discharge might

be low when using them the first and second time.

This is a temporary phenomenon, and normal time

required for recharging will be restored by recharging

the batteries 2 – 3 times.

How to make the batteries perform longer.

(1) Recharge the batteries before they become completely

exhausted.

When you feel that the power of the tool becomes

weaker, stop using the tool and recharge its battery.

If you continue to use the tool and exhaust the electric

Engraved characters

Part Name

Engraved

L B Code No.

characters

4 mm Hexagonal socket 7 65 7 992689

5 mm Hexagonal socket 8 65 8 996177

6 mm Hexagonal socket 10 65 10 985329

5/16" Hexagonal socket 12 65 12 996178

8 mm Hexagonal socket 13 65 13 996179

10 mm Hexagonal socket

14 65 14 996180

(small type)

10 mm Hexagonal socket 16 65 16 996181

10 mm Hexagonal socket 17 65 17 996182

1/2" Hexagonal long

socket

21 166 21 996197

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi WH 12 DAF Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info