Bedienungsanleitung Hitachi wr14dm (Seite 47 von 54) (Englisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

381177

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

English

Optional accessories are subject to change without

notice.

APPLICATION

⅜ Tightening and loosening of all types of bolts and

nuts, used for securing structural items.

BATTERY REMOVAL/INSTALLATION

1. Battery removal

Hold the hadle tightly and push the battery latch

to remove the battery (Figs. 1 and 2).

CAUTION

Never short-circuit the battery.

2. Battery installation

Insert the battery while observing its polarities (see

Fig. 2).

CHARGING

Before using the impact wrench, charge the battery as

follows.

1. Connect the charger’s power cord to a receptacle

When the power cord is connected, the charger’s

pilot lamp will blink in red (At 1-second intervals).

2. Insert the battery into the charger

Insert the battery firmly, in the direction shown in

Fig. 3, until it contacts the bottom of the charger

compartment.

CAUTION

If the battery is inserted in the reverse direction,

not only recharging will become impossible, but it

may also cause the fuse to blow, or problems in

the charger such as deformed recharging terminal.

3. Charging

When inserting a battery in the charger, charging

will commence and the pilot lamp will light

continuously in red.

When the battery becomes fully recharged, the pilot

lamp will blink in red (At 1-second intervals) (See

Table 3).

(1) Pilot lamp indication

The indications of the pilot lamp will be as shown

in Table 3, according to the condition of the charger

or the rechargeable battery.

Table 3

Indications of the lamps

Lights for 0.5 seconds. Does not light for

0.5 seconds. (off for 0.5 seconds)

Lights continuously

Lights for 0.5 seconds. Does not light for

0.5 seconds. (off for 0.5 seconds)

Lights for 0.1 seconds. Does not light for

0.1 seconds. (off for 0.1 seconds)

Lights continuously

Before

charging

While

charging

Charging

complete

Charging

impossible

Charging

impossible

Blinks

(RED)

Lights

(RED)

Blinks

(RED)

Flickers

(RED)

Lights

(GREEN)

Malfunction in the battery

or the charger.

The battery temperature

is high, making recharg-

ing impossible.

(2) Regarding the temperatures of the rechargeable

battery

The temperatures for rechargeable batteries are as

shown in the table below, and batteries that have

become hot should be cooled for a while before

being recharged.

Table 4 Recharging ranges of batteries

(3) Regarding recharging time

Depending on the combination of the charger and

batteries, the charging time will become as shown

in Table 5.

Table 5 Charging time (At 20°C)

NOTE

The charging time may vary according to

temperature and power source voltage.

Temperatures at

Rechargeable batteries which the battery

can be recharged

EB14B –5°C – 60°C

EB1430H 0°C – 45°C

Charger

UC14YFA

Battery

EB14B Approx. 50 min.

EB1430H Approx. 70 min.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hitachi wr14dm Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hitachi wr14dm

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info