30180
4
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
DCX Receiver:
Included in the Lynx 3D system is the most advanced surface use receiver on the market today. The
Hitec DCX receiver features dual conversion technology that filters the transmitter’s signal twice,
decreasing the chance of stray RF “noise” causing interference. This “dual conversion” feature
produces the best performance possible in even the most demanding conditions.
Note: When used with and ESC (Electronic Speed Control) the receiver is powered by the ESC
through the throttle channel. When used in a vehicle without an ESC, such as gas or glow engine,
the receiver must be powered with an external 4.8V - 6.0V battery pack that is plugged into the Bat/
DSC channel.
Channel assignments on the DCX receiver:
CH1: Steering
CH2: Throttle
CH3: Auxiliary
Bat/DSC: Battery and DSC (direct Servo Control)
HFS-03MC Receiver:
Included with the Lynx 3D (Some Non U.S. version only) is the 03MC single conversion receiver. The
03MC is the best performing single conversion receiver available today and is also available sepa-
rately as a lower cost alternative to the DCX.
Note: When used with an ESC (Electronic Speed Control) the receiver is powered by the ESC
through the throttle channel. When used in a vehicle without and ESC, such as a gas or glow engine
vehicle, the receiver must be powered with an external 4.8V - 6.0V battery pack that is plugged into
the Bat/DSC channel.
Changing Frequencies:
When using the system in competition environment it may be necessary to change the systems
operating frequency.
Receiver:
Receiver crystals can be changed within the entire band with no loss of performance. Use only
genuine Hitec Dual Conversion receiver crystals in the DCX receiver and only genuine Hitec Single
Conversion crystal in the HFS-03MC receiver.
Transmitter:
The Lynx 3D is equipped with a frequency module and has a crystal plugged into it. You can change
between the 27MHz and 75MHz bands by changing the entire module. To change channels in the
transmitter within the band, it is recommended you replace the entire module tuned to a specific
frequency for maximum performance. However the crystals may be replaced in the module but it will
reduce the performance slightly. Use only genuine Hitec crystals.
Transmitter NiCads and Battery Charging:
The Lynx 3D comes equipped with NiCad batteries in the transmitter and an “overnight” charger for
your convenience. To charge the batteries simply connect the charger to the charging port in the
transmitter case or in the battery box. This can be done while he batteries are in or out of the
transmitter. Normal charging time is approximately 12-18 hours. Caution: Batteries should not be
left on charge for longer than 24 hours.
3
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitec LINX_3D wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info