Bedienungsanleitung Hotpoint SGDC11AA1 (Seite 13 von 16) (Englisch)

665369

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

1313

• The plug was not inserted or is not making contact.

• Make sure the temperature is not set to Min.

• The temperature indicator light is on. This shows that the iron is

warming up. The indicator light will turn off when the set temperature

is reached.

• Not enough water in the water reservoir. Fill up the water reservoir.

• The iron is not hot enough. Place the iron on the special supporting

base and wait until the temperature indicator light turns off before you

start ironing.

• The plate temperature may be too low because the steam button

has been activated too frequently. Slightly increase the time interval

between steam shots.

• Make sure the steam control is not set to Min.

• There may be residues in the vaporisation chamber. Clean it as

shown in the chapter “Cleaning and maintenance” under paragraph

“Descaling”.

• You are using perfume, vinegar, starch, scale-removing agents,

ironing products or other chemicals. Remember that these substances

may damage the product. Rinse the water reservoir.

• You are not using the correct water type. Rinse the water reservoir

and add tap water only. In case of very hard water, we recommend

mixing it proportionally with demineralised water - see chapter "Filling

the water reservoir".

• You are using starch. You can use starch directly on the reverse side

of the fabrics and in any case never in the water reservoir.

• The garment was not washed correctly or it has some soap residues.

• Youareironinganewgarmentnotyetwashedforthersttime.

• The plate temperature may be too low because the steam button

has been activated too frequently. Slightly increase the time interval

between steam shots.

• The soleplate temperature is set to a temperature that is too low.

• You used the shot-of-steam function and/or the steam function at a

temperature that was too low. We recommend using these functions

attemperatureshigherthan●●●.

• You are using a temperature that is too high.

• Clean the soleplate - see chapter “Cleaning and maintenance” under

paragraph “Cleaning”.

• You are using starch. You can use starch directly on the reverse side

of the fabrics and in any case never in the water reservoir.

• The garment was not washed correctly or has some soap residues.

• Youareironinganewgarmentnotyetwashedforthersttime.

The soleplate stays cold and

does not warm up.

The temperature indicator

light goes on and off.

Steam comes out in a re-

duced quantity or does not

come out at all.

Impurities coming out of the

soleplate stain the garments.

Water is dripping out of the

soleplate.

The soleplate is dirty or dark

and may stain the fabrics.

TROUBLESHOOTING

Problem Possible causes / Solutions

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint SGDC11AA1 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info