6
GB
INSTRUCTIONS FOR USE:
Changing Attachments
To change the attachments, simply twist off (anti-clockwise)
the set that is attached to the unit and twist on (clockwise)
the desired set. (See Figure 1)
Massage Function
NOTE: Always ensure the appliance is set to the ‘OFF’
before inserting the plug into a mains outlet.
1. Plug the appliance into a 230V mains outlet and switch on.
2. Slide the power switch upwards to start the massage. Slide up
one (I) position for low intensity setting and two (II) positions for high intensity setting.
3. Apply the massager head lightly to the area you wish to treat. Move the unit slowly, holding
it over the targeted area. Treat the area for a short period of time and move to another area. NEVER treat
the same area for longer than 3 minutes.
4. To turn the unit off, slide the power switch downwards to the‘OFF’position.
Heat Function
1. Attach the red massage head as described in the‘Changing Attachments’section above.
2. First activate the massage function as described above. Then slide the‘Heat’ switch upwards to active the
heat. Allow a few minutes for the heat to fully activate.
3. To turn the heat off, slide the switch downwards to the‘OFF’position.
NOTE:
• To eliminate risk of being burned, only use the heat function with the red heat attachment.
• The Heat function will only work when the massage is in use.
• DO NOT use the massage or heat functions continuously for more than 15 minutes.
• DO NOT use the massager directly on one concentrated area of the body. Percussion action massagers are
designed to be used in a continuous motion, constantly changing the massage area.
(Figure 1)
