Bedienungsanleitung Homedics WFL-RVRB-2 (Seite 4 von 29) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

518476

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

Figure 8

Front Plate

PumpInlet

Impeller

ubing

ousing

SuctionFeet

FlowControlLever

TROUBLESHOOTING :

If the pump fails to operate, check the following:

Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical

power.

NOTE: Always disconnect from electrical outlet before handling the pump.

Check the pump discharge and tubing for kinks and obstructions. Algae build up can be flushed

out with a garden hose.

Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not broken or

jammed.

Monthly maintenance will add to your pump’s life.

NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip Loop’. This

will prevent water from running down the cord into the electrical outlet.

If the pump gurgles, spews, or “burps”:

Check the water level to make sure the pump has enough water to function.

Obtaining a desired water level:

Check the water level daily the first week to measure the rate of evaporation; refill with water as

needed.

If water is splashing outside the fountain:

Rocks that are hit by water and also touch the edge of the base will cause water to splash

outside of the base and contribute to the splash factor. Expect some splash to occur as you get

the rocks organized.

If splash continues, adjust the flow control valve to a lower setting, and/or rearrange

the river rocks by moving them away from the edge of the base.

CAUTION:

All servicing of this fountain must be performed by authorized HoMedics

service personnel only.

ATTENTION:

In order to get best results, please operate pump completely submerged.

Keep the water level above the minimum water level ALL THE TIME.

MAINTENANCE :

To clean the pump:

Unplug from electrical outlet. Remove it from the base of the fountain. Use a small brush or

stream of water to remove any debris (Fig 8).

To keep water clean:

Periodically change water and clean the product according to the water condition. Keeping the

water clean prevents the water from becoming sticky and forming micro-organisms.

To clean off hard water deposits on the base or rocks:

Soak the container and rocks in a mixture of vinegar and water to clean and remove any mineral

build-up.

Keeping the water at an optimum level:

Add water periodically to keep water level at an optimum level to avoid shortening the life of the

pump.

NOTE: Never let the pump run dry, as this will shorten the life of the pump.

Fountain Storage

Unplug the fountain from the electrical outlet, empty the water, and store rocks and fountain in a

dry, cool place.

Plug (MODEL WFL-RVRB-3GB ONLY)

If the plug on this appliance is damaged, it can be replaced

with a BS 1363 plug, fitted with a 3A BS 1362 fuse.

Only use a 3amp fuse with this appliance.

Care must be taken when changing the plug.

If in doubt, contact a qualified electrician.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Homedics WFL-RVRB-2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info