56
Hazard switch
This system should be used only when your
motorcycle is stopped under emergency or
hazardous conditions. To turn it on, turn the
ignition key to the ON position, and then slide
the switch marked .The front and rear turn
signals will blink simultaneously.
All of the turn signals can blink without the
ignition key.
To operate this function, proceed as follows:
1. Turn the ignition key to ON position and
then slide the hazard switch (1) to the
marked position.
2. All of the turn signals will keep blinking
even after you turn the ignition key to OFF
position.
3. You can turn off the turn blinking signals
by sliding the hazard switch back to the off
position.
If the switch is left in the off position for
more than two seconds and then moved
back to the position again, the turn
signals will not be on.
Be sure to turn the switch off when the hazard
warning is no longer required, or the turn
signals will not work properly, and may
confuse other drivers.
If all the turn signals are left blinking with the
engine stopped, the battery will be
discharged.
(1) Hazard switch
(1)
